Netduma Fraser

The game/console will periodically communicate with servers, that is why it is being picked up. If the console was fully off it would stop

Geo-Latency can allow for servers to be connected to outside the radius so if you don't want that then you'd need to disable it. The next update will be a big one and they should be more frequent after that.

Okay that won't be it then, do you have ALL devices connected to the R3? What firmware version are you on?

Okay thanks I'll pass it on to the team!

I don't know what that means specifically, can you clarify?

You can yes, if you factory reset though it's likely the IP you entered into the DMZ will change so either double check and re-enter if necessary or on the hub set the R3 to have that IP as static/reserved so it never changes

Okay that's good, it can take a few days or longer for some providers when you introduce a new router to have it provide full speeds. How long have you had the R3 connected?

It shouldn't make a difference really whether you can ping it or not but for those ones where it doesn't play well deny the server so you don't play on it again

If you just have your radius over your area you wouldn't be able to connect to him so it might make it force you as the host instead

It's not always possible to ping the server unfortunately but I am talking to the team about it

Disable Geo-Latency as that will help keep the game within your radius, see if it works better then

You can do yes, just keep in mind QoS won't work as effectively in that scenario as it can't control the devices not connected to it

How far away is the friend in relation to you? What is the ping when they host?

They'll both work regardless but always best to have ALL devices connected to the R3

Is that DMZ on the R3 or DMZ on the provider router?

Let us know if the above process works!

Is the gaming device still on even in an instant on/standby state?

Did you split the WiFi bands? If not its likely your device is using 5GHz at that time and will then switch to 2.4GHz when needed.

Factory reset can be done either via the interface or by holding the reset button in the back of the router for 30 seconds. Unplugging is just a reboot. The firmware is attached to the first post on that link, there is also an alternate download link at the bottom of that post.

As above, your confirmation is also likely in your spam/junk folder. If not and you want it email [email protected] and we can get a confirmation over to you

Can you provide a screenshot of the Geo-Filter showing what you see when this happens please? We don't have telephone support as we're still a small company

What is the model of the modem/router the R3 is connected to and how have you set that to ensure all traffic flows to the R3? E.g. R3 in its DMZ, modem/bridge mode What speeds do you pay for/expect and what are you receiving? Presumably you're testing via ethernet?

No it's the same firmware but best to do a factory reset after upgrading

Try the latest here: https://forum.netduma.com/topic/53938-new-r3-firmware-4041/

Okay please let us know if it happens again!