Jump to content

Sick of this now


Recommended Posts

  • Administrators

Change your security mode to PSK2. 

 

Someone on the forum experiencing issues when wireless devices were located near the router. You could try moving any away from the router and see if that resolves your issues.

Link to comment
Share on other sites

i have tried a factory reset, rebooting from misc, changed to wpa-psk2 but it still drops out. this time it did it so i rebooted and it forgot everything from disabled ipv6 options to devides connected. had to basically enter all info again from connection speeds to congestion. the only device even close to it is the black sky hub.

Link to comment
Share on other sites

Hi Baz (it was you I ran into on BO3 on Xbox I think!).

 

Don't know if you've tried this already but have you run a wifi scanner to pick the least congested channel near you?

I was shocked by how many of my neighbours were hammering the same two channels and I saw an immediate improvement when I changed the broadcast channel.

 

It's easy to do if you have a Mac, not sure about PCs, I expect Zennon knows a good piece of software for the PC to do it.

 

I've got a feeling Apple devices work better (range) on different broadcast channels too but I might have imagined it.

Link to comment
Share on other sites

Just a suggestion: If you have an existing router prior to the R1 I would use it as an access point for all of your wireless needs.  That way you will be able to have access to 2.4Ghz as well as 5Ghz channels.  Setup would look something like this Modem>R1>Other Router as Wifi Extender(Access Point). 

Link to comment
Share on other sites

It's easy to do if you have a Mac, not sure about PCs, I expect Zennon knows a good piece of software for the PC to do it.

 

baz has had this issue for a while and I have suggested this in the past but i will post again.

 

http://www.howtogeek.com/197268/how-to-find-the-best-wi-fi-channel-for-your-router-on-any-operating-system/

Link to comment
Share on other sites

i tried two different channels and both went off on wifi. i then turned off the netduma as a test for the last 2 days and ran the house off just the sky hub and it never went off once. i have looked in this loads in forum and wiki but there are so many different little things to do that i could well have missed something. we are now set up running everything through the duma again and i have set the sky hub as instructed to on here e.g dmz, wan and lan, wireless off etc

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...