SaraYK Posted November 2, 2020 Share Posted November 2, 2020 how do i remove the double nat issue on the r2? Link to comment Share on other sites More sharing options...
Administrators Netduma Alex Posted November 2, 2020 Administrators Share Posted November 2, 2020 The best way is to put your ISP router into Bridge Mode, but if this is not possible, the next best solution is using DMZ. To do this, open DumaOS, go to the System Information page and write down your WAN IP. Now open the web interface for your ISP router, and look for a DMZ option. You need to put the WAN IP you just wrote down into the DMZ. Also, make sure that UPnP is turned on in DumaOS. Link to comment Share on other sites More sharing options...
SaraYK Posted November 3, 2020 Author Share Posted November 3, 2020 router is in bridge mode, however access the comcast rental router/modem. dmz is disabled. Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted November 3, 2020 Administrators Share Posted November 3, 2020 Will need more information, what is the exact physical setup? How did they enable the bridge mode? What settings are they using on the R2 to try and get an open NAT? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.