Why is th R3 not helping with buffer bloat?

[Mach3r]

I have been tweaking the settings and still getting performance like this. Any suggestions? 

[Aspect of Wrath]

Is every device connected to the r3? Did you set ping optimizer to always instead of auto when you do these tests?

[DARKNESS]

@Mach3rYou won’t get accurate results if the speed test bypass is enabled. You need to disable it. Also, set the congestion control mode to "Always On."

[Netduma Fraser]

How did you get on after the above comments? 

[L7NALMARI]

On 12/18/2025 at 1:13 AM, Aspect of Wrath said:

Is every device connected to the r3? Did you set ping optimizer to always instead of auto when you do these tests?

I have the same problem i set to always nothing change @Aspect of Wrath

 

 

[L7NALMARI]

On 12/18/2025 at 3:57 AM, DARKNESS said:

@Mach3rYou won’t get accurate results if the speed test bypass is enabled. You need to disable it. Also, set the congestion control mode to "Always On."

What do mean bypass is enabled @DARKNESS

[Krush]

Cela signifie qu’un test de vitesse (reconnu par la DPI) contourne les règles ABB mise en place avec le pourcentage !

Il faut le désactiver quand vous voulez tester l’efficacité d’ABB

ABB = AntiBufferBload

[Netduma Fraser]

6 hours ago, L7NALMARI said:

What do mean bypass is enabled @DARKNESS

What is the model of the modem/router the R3 is connected to and how have you set that to ensure all traffic flows to the R3? E.g R3 in its DMZ, modem/bridge mode

Are ALL devices connected to the R3?

Are the speeds you pay for/receive 1000/100? 

How have you setup Congestion Control?

[Eefo]

5 hours ago, Netduma Fraser said:

What is the model of the modem/router the R3 is connected to and how have you set that to ensure all traffic flows to the R3? E.g R3 in its DMZ, modem/bridge mode

Are ALL devices connected to the R3?

Are the speeds you pay for/receive 1000/100? 

How have you setup Congestion Control?

Do you have to put r3 in DMZ mode too or just putting modem/router in bridge mode will do?

 

 

[Netduma Fraser]

40 minutes ago, Eefo said:

Do you have to put r3 in DMZ mode too or just putting modem/router in bridge mode will do?

Modem/bridge mode is good too!