CrossFitKila717 51 Posted September 20, 2019 Hello, I just reverted back to OG firmware & can’t remember a few things.......First being, what’s “Multicast Snooping” & what does it do? Also, should I have “UPNP Forwarding” enabled if I have UPNP enabled? Thanks! Share this post Link to post Share on other sites
pollutionblues 1,759 Posted September 21, 2019 8 hours ago, CrossFitKila717 said: Hello, I just reverted back to OG firmware & can’t remember a few things.......First being, what’s “Multicast Snooping” & what does it do? Also, should I have “UPNP Forwarding” enabled if I have UPNP enabled? Thanks! Don worry about multicast snooping unless you are using a media centre. UPnP Forwarding is used to open ports when you use an upstream router. If you already have an open NAT don’t worry about enabling it. 2 CrossFitKila717 and Netduma Fraser reacted to this Share this post Link to post Share on other sites
Netduma Fraser 8,700 Posted September 21, 2019 As above! Let us know if you have any other questions! 1 CrossFitKila717 reacted to this Share this post Link to post Share on other sites
CrossFitKila717 51 Posted September 21, 2019 10 hours ago, pollutionblues said: Don worry about multicast snooping unless you are using a media centre. UPnP Forwarding is used to open ports when you use an upstream router. If you already have an open NAT don’t worry about enabling it. Great thanks!! So just enable my UPNP under “UPNP” section.......but leave it disabled under the miscellaneous settings section, correct? Share this post Link to post Share on other sites
Netduma Fraser 8,700 Posted September 21, 2019 Exactly! 1 CrossFitKila717 reacted to this Share this post Link to post Share on other sites
