congestion control not work with waveform

[justin peryea]

I turned off smart boost and it hits 500 than shoots down to 234 and download little slow 684 that with r3 test 

[Netduma Fraser]

It's probable the Verizon test is only available and works as expected when connected directly to their hardware. What other sites are you using to test? What does the speedtest on the R3 show you can get?

[justin peryea]

speed test .net 650/200  r3 680/180  on my phone 80/60 it's real bad tried different ports switch to 100 full duplex on pc still nothing it strange to cause i plugged back in xr 500 same thing but verzion router works fine 

[nate208]

Just jumping in to this topic as I am also not able to get CC to work as advertised on waveform test and following guides online to reduce buffer bloat. On .41 firmware.

Also have Verizon Fios 1gig/1gig. Seeing 900ish down and <300 up.

[Netduma Fraser]

2 hours ago, justin peryea said:

speed test .net 650/200  r3 680/180  on my phone 80/60 it's real bad tried different ports switch to 100 full duplex on pc still nothing it strange to cause i plugged back in xr 500 same thing but verzion router works fine 

I'm a bit stumped on this one really as there is obviously something preventing it on the Verizon/modem/ONT side getting any further. Have you just upgraded the speeds or switched providers by any chance?

2 hours ago, nate208 said:

Just jumping in to this topic as I am also not able to get CC to work as advertised on waveform test and following guides online to reduce buffer bloat. On .41 firmware.

Also have Verizon Fios 1gig/1gig. Seeing 900ish down and <300 up.

Could you make a new topic please as it'll be a different thing - you probably need to disable Speed Test Bypass so the percentages apply properly to the test.

[justin peryea]

i have had verzion for 3 years now no speed changes its so weird cause the xr500 was working fine  too after I upgraded my pc before new pc it was doing the same thing slow speeds what r the chances of it being a faulty r3? 

[justin peryea]

the only other i haven't tried is staic ip but I'm a little confused on how to set that up

[Netduma Fraser]

Very unlikely to be faulty if you're seeing the same with the XR. What is the exact model of the Verizon modem you're using?

[justin peryea]

not sure not a model number on it it's just a white box should I bridge mode verzion router? I keep going down rabbit holes online about different things lol 

[Netduma Fraser]

You can try that yes, it may help. It should have a model number on a sticker underneath it

[justin peryea]

stumped big time it didn't the help the only thing it did help was with the Verizon test  it finishes now but all other sites r slow speeds 800/200

[Netduma Fraser]

What's the Verizon modem model? Then I can research it and see what else can be done

[justin peryea]

this is bottomnof verizon box

 

[justin peryea]

new test my upload went to 500 for 2 seconds than back to 200 it acts like it wants to get full speed than stops 

[Netduma Fraser]

Nothing on that label that indicates the model, if you have a look on the interface itself can you get any more information on the model?

[justin peryea]

CR1000A

[Netduma Fraser]

Thanks, I'll research and come back to you

[justin peryea]

thank u u guys r the best 

[justin peryea]

any luck?

[Netduma Fraser]

Couple of things to try:

1. Set Firewall to low
2. Enable SIP ALG
3. Give the R3 a static/reserved IP on the hub and put in the DMZ

[justin peryea]

litter more info on the 3rd one  I put r3 in dmz than take that ip and put in the verzion router 

[justin peryea]

did the first two no luck 

[justin peryea]

just checked my phone speed test it's way better!!!!!!! wired not so much

[Netduma Fraser]

15 hours ago, justin peryea said:

litter more info on the 3rd one  I put r3 in dmz than take that ip and put in the verzion router 

The R3 WAN IP should be set as static/reserved on the Verizon router so the IP doesn't change, then put that in the DMZ

[justin peryea]

I think I did it and it made my upload slower