Startup Process

[VibzX]

i just got my netduma r2 router this morning and was wondering how to set it up. i followed the manual that came with it but the network doesn’t seem to pop up on my laptop.

[Netduma Fraser]

Hello, welcome to the forum!

Connect your PC via ethernet to the R2 then enter 192.168.77.1 into your web browser, does that allow you access to the Setup Wizard?

[VibzX]

no it did not let me.

 

[Netduma Fraser]

While connected to the router via a Windows PC, open command prompt, type ipconfig press enter and then post a screenshot of the results here please.

[VibzX]

[Netduma Liam]

Looking at your original screenshot, you appear to have the cable for the R2 connected to the modem's Internet port. Does the modem have a LAN port you can connect that cable to instead? What's the make and model of the modem exactly?

[VibzX]

[Krush]

You must also put an RJ45 cable from R2 (yellow port) to your PC!

[VibzX]

9 minutes ago, Fuzy said:

You must also put an RJ45 cable from R2 (yellow port) to your PC!

i did when he asked to go onto the website

[Krush]

Is your Lan on the PC activated?

Type control panel on the W11 search then network center and sharing / modify the card settings

[VibzX]

13 minutes ago, Fuzy said:

Is your Lan on the PC activated?

Type control panel on the W11 search then network center and sharing / modify the card settings

 

[Krush]

1-Try another ethernet cable

2-Manually change your ipv4 address (ethernet PC card)

192.168.77.100

255.255.255.0

192.168.77.1

Restart the pc and the R2 and try to reach the web page 192.168.77.1

3-If not, try a manual factory reset behind the R2!

[Netduma Liam]

Good suggestion, above, particularly trying a new ethernet cable!