Bypass/loop through Netduma R2

[SachsenPowl]

Hi,

is there a way to bypass Netduma Router, to get only connected via my AiO? I want to test if my AiO performs better, but my cable laid nicely (cable management system) and i dont want to crash this..

btw: i finally found a good setting for the R2, i just want to test a few things.

Right now my Setting is: Room1 AiO -> Room2 Netduma R2 (static IP) -> Desktop PC (static IP)

thx for this.

[Netduma Fraser]

The only way would be to connect to the AIO directly, as it is a router you can't bypass it

[SachsenPowl]

OK ... . If i reset my R2 Settings and start from scratch, before setup, i get 4 minutes to test this. In this 4 Minutes the Router act like a Switch. So i wonder why it is "impossible" to implement this into firmware...

[Netduma Liam]

Currently this isn't possible on the R2, routers that have modes where they can essentially just be an access point may be closer to what you're looking for, but that wouldn't work with the R2 as you wouldn't be able to use any features of the software.