XR500 CPU1 capping at 100%

[Jambo]

Hi,

I tried out DumaOS 3.0 .114, and my CPU1 is very high, consistently peaking at 100%. CPU0 is around 70-80%. This was a fresh install with factory reset (in fact, I factory reset it several times), and set it up from scratch. No matter what I do, I can't get CPU1 to go down. 

Downgrading back to .66 yields the same issue, there both CPU0 and CPU1 are stuck at 100%. Again, factory reset.

Router is idle, theres no big upload/downloads happing, no special geofiltering is present..Any ideas?

I noticed that this started happening after a Connection Benchmark froze on Ping Test (Under Load). I've since restarted the router several times, as well as factory resetting, downgrading, etc. Nothing works.

[Jambo]

Doesn't matter what browser or computer I try, the results are consistent.. Firmware was manually set up after factory reset, no restoring backups.

 

[Jambo]

After several factory resets, seems the issue has subsidded. Back on .66, wont be going back to the beta until its a final release.

[Netduma Liam]

Good work on fixing this! Did you notice the XR being particularly hot while the CPU was at 100%? You'd think it'd be kicking out some heat at that point...

I'll see if we can reproduce this and work out why this happened, thank you!

[Jambo]

It was warm to the touch yes, which is why I was trying everything I could to get it back down. Didn't want it overheating/dying. I'm assuming that when the latency test (under load) is done, it artificially loads up the CPU to test latency? seems like it got stuck in this state.

[Netduma Fraser]

It will be a bit warm as it's on for long periods of time but unless it's really hot that shouldn't be too concerning. If you disable QoS completely, reboot, then enable it again has CPU reduced?