patnj Posted November 2, 2020 Share Posted November 2, 2020 Hi, During the setup wizard (after factory reset), spaces are not allowed in the Wifi SSID name (Network name), however you can workaround this by editing the SSID (Network name) later from the "Network Settings->Wifi" tab, which allows spaces to be entered. @Netduma Fraser can this be addressed in the next firmware release. This caused an issue when upgrading from .138 to .179 following a factory reset. Link to comment Share on other sites More sharing options...
Newfie Posted November 2, 2020 Share Posted November 2, 2020 Yes the SSID name should have a space if ones needed. did you reset using software or rear pin after update? Link to comment Share on other sites More sharing options...
patnj Posted November 2, 2020 Author Share Posted November 2, 2020 Software-> factory reset via the below Link to comment Share on other sites More sharing options...
Newfie Posted November 2, 2020 Share Posted November 2, 2020 I never use the software reset, I use the pin hole method as I’m not loaded in the GUI. Link to comment Share on other sites More sharing options...
Administrators Netduma Alex Posted November 2, 2020 Administrators Share Posted November 2, 2020 That's a good catch, thanks for pointing it out! I'll make an internal bug ticket. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.