Jump to content

wifi access point issues


Recommended Posts

When I go to put my nighthawk router into AP mode and connect it to my netduma, for some reason I only get like 5 mbps wifi with the nighthawk. I'm pretty sure I have it setup correctly so how come I get basically no speeds through my nighthawk wifi with it plugged into my netduma? Any help would be very appreciated..

Link to comment
Share on other sites

When I go to put my nighthawk router into AP mode and connect it to my netduma, for some reason I only get like 5 mbps wifi with the nighthawk. I'm pretty sure I have it setup correctly so how come I get basically no speeds through my nighthawk wifi with it plugged into my netduma? Any help would be very appreciated..

 

Is WMM on in advanced wireless settings? I had a similar issue

Link to comment
Share on other sites

In the nighthawk settings you mean? When I connect my router to my netduma and set the netduma up properly, I should be able to use my 5G wifi but I get extremely low speeds regardless if I have turbo/super turbo enabled. Surely I should be able to get more than 5 mbps wifi off of this setup right?

Link to comment
Share on other sites

In the nighthawk settings you mean? When I connect my router to my netduma and set the netduma up properly, I should be able to use my 5G wifi but I get extremely low speeds regardless if I have turbo/super turbo enabled. Surely I should be able to get more than 5 mbps wifi off of this setup right?

 

Is WMM on in advanced wireless settings on the Nighthawk?

Link to comment
Share on other sites

  • Netduma Staff

In the nighthawk settings you mean? When I connect my router to my netduma and set the netduma up properly, I should be able to use my 5G wifi but I get extremely low speeds regardless if I have turbo/super turbo enabled. Surely I should be able to get more than 5 mbps wifi off of this setup right?

 

Hi, welcome to the forum! First off, try out these settings for the R1:

- Reactive Algorithm
- 100% anti-flood
- Disable IPv6 in WAN, LAN & misc
- Disable deep packet in misc
- Enable turbo mode
- Enable super turbo mode
- Ensure the ethernet cables you're using connecting the R1 to hub & R1 to PC are Cat5e+/can handle your speeds.
- Do a wired speed test from a PC
 
And just to get all the obvious things out of the way, try a different Ethernet cable / different ports as well please.
Link to comment
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...