network monitor

[riggs540]

With all the talk of pppoe increasing the router cpu load / speed reduction. I have put another router to do the pppoe / dmz which is working fine .

 

I have noticed that the network monitor graphs dont seem to draw most of the time .

 

If i just put it back to modem/netduma it works all the time .

 

I have tried three different routers to do the pppoe / dmz and the results is the network monitor doesnt work very often.

 

It does seem really odd as i assume the graphs are generated from what goes through the wan port.

 

Had this problem with .5 as well.

 

Anyone else using a middle router seen this issue ?

[iAmMoDBoX]

Mine isn't working since the .6 update

[Netduma Fraser]

Are all devices connected to the R1 in this scenario? 

[riggs540]

yes i just put the other router inbetween and left everything everything as it was

[Netduma Fraser]

yes i just put the other router inbetween and left everything everything as it was

 

This may be because it requires direct from modem > R1 then. Can anyone else confirm if theres works with modem > router > R1?

[Netduma Crossy]

If you right click on the Network monitor and click inspect element then look at the console, do any errors show up?

[riggs540]

ok ill put it back on friday night and checked it out

 

thanks

[riggs540]

yes i do have a error something about unmatched ip 192.168.0.100 . This is my dmz ip .

 

Any thoughts?

 

thanks riggs

[Netduma Fraser]

Iain may have to look into this but he is quite busy at the moment. 

 

Can you check the WAN IP in device manager and make sure that is the same as what you have input and that it hasn't changed.