ThePhyter Posted November 4, 2015 Posted November 4, 2015 I want to run my R1 when my gateway is in bridge mode, but when I turn on bridge mode and wait for gateway to reset, I then turn off R1 and turn back on and then it displays I have no WAN IP and I have no internet obviously. I want to know what I have to do to get it to work correctly when I have it in bridge mode. I also have the newest Xfinity 105.
Administrators Netduma Fraser Posted November 4, 2015 Administrators Posted November 4, 2015 Put it in bridge mode and then power off gateway & Netduma. Disconnect all devices from the Netduma if wired. Connect port 1 of the Duma into port 1 on the gateway. Power up the gateway and after a minute, power up the Netduma and connect your devices to the duma.
kinel Posted November 4, 2015 Posted November 4, 2015 If frasers idea didnt work you could try manualy type your routers mac adress into the wan ip adress of netduma
lefteris.lydios Posted November 4, 2015 Posted November 4, 2015 OK, maybe this is a stupid question, but can we use a bridged router as an access point or repeater?
ThePhyter Posted November 4, 2015 Author Posted November 4, 2015 Thank you. What Fraser said did work. Annoying that I had to do all that to get it to finally work. Bu thanks anyways.
kinel Posted November 4, 2015 Posted November 4, 2015 Glad to see it works Frasers advicse always works lol
Administrators Netduma Fraser Posted November 4, 2015 Administrators Posted November 4, 2015 OK, maybe this is a stupid question, but can we use a bridged router as an access point or repeater? I don't believe so but could be wrong. Thank you. What Fraser said did work. Annoying that I had to do all that to get it to finally work. Bu thanks anyways. Great to hear it's resolved, I'll close the thread, feel free to make another if needed.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.