XR1000 can't get into firmware. Password not working and Wifi disabled.

[Heroxoot]

I just bought an Xr1000. Earlier today the wifi disabled and when I try to access the firmware it won't let me in. I've had it for 3 days. 

[Heroxoot]

I just had to do a full factory reset because the router refused my password and could not open the reset password form. The password is literally saved in my browser FFS. Never had such issues with my XR450.

[Heroxoot]

For whatever reason the automatic update only took me to 1.0.0.64. I manually updated to .74 and it seems better so far. I'll give it a few days.

[DARKNESS]

I believe that the Netduma staff are off since it is the holidays, but they should be back tomorrow. After upgrading the firmware, I would definitely perform a factory reset. I've seen that happen here and there, and typically it is because your IP is conflicting with your setup.

[Heroxoot]

3 hours ago, DARKNESS said:

I believe that the Netduma staff are off since it is the holidays, but they should be back tomorrow. After upgrading the firmware, I would definitely perform a factory reset. I've seen that happen here and there, and typically it is because your IP is conflicting with your setup.

Yeah so I updated it via auto update to .64. There was no reset needed it was already a fresh factory reset from the box. So far it's fine, not sure why 1.0.0.74 doesn't show up on the auto update. After updating to 1.0.0.74 it was super laggy in the settings and it couldn't load it's own firmware pages. Then suddenly it just solved itself and it's functioning normally. Perhaps something had not fully finished internally after the firmware update.

[Netduma Fraser]

NG haven't pushed .74 to the atuo update, I'm not sure why. Glad it's working now though!