Nat moderate warzone2

[David marin]

Hi

I have Nat moderate on warzone 2

upnp is enable

I opened ports

and continue wit the same Nat

[Netduma Fraser]

What platform are you playing on? If a console does it say moderate on the console network test?

[David marin]

Sorry 

Its on Pc

[Netduma Fraser]

Have a run through of this guide and see if that gets you sorted:

https://support.netduma.com/support/solutions/articles/16000076587-dumaos-optimal-settings-guide-open-nat

[David marin]

I tried everything and continue Nat moderate

[David marin]

I tried again about DMZ and now is open

thank you so much

[Netduma Fraser]

I wouldn't recommend putting your PC in the DMZ, what is the model of your ISP modem/router and is that in modem mode or did you put the R2 in its DMZ?

[David marin]

It’s Sagemcom fast 3890v2 modem

I put both on DMZ

[David marin]

I disable DMZ again and then I have Nat moderate again

[Netduma Fraser]

It's quite likely that it's a misreading, disable the Geo-Filter before you load up the game, does it appear open then?

[David marin]

Not, continue moderate

[Netduma Fraser]

Check your NAT status on Windows:

Go to Settings > Gaming > Xbox Networking

It will automatically run the test, this will usually fail

Click 'Fix it' and wait for the confirmation message

Click 'Check again'

It should come back with your NAT type

If it is Open then it is highly likely the game is misreading your NAT Type.

[David marin]

I don’t have that option to check

[David marin]

It’s Sagemcom fast 3890v2 modem

I put both on DMZ

[David marin]

I found it. My OS is windows 11

[Netduma Fraser]

Did you do fix it and check again? It always seems to fail on the first test

[David marin]

I don’t have the optio to click “fix it”

[Netduma Fraser]

Was it the WAN IP from the R2 System Information page that you put in the Sagecom DMZ?

[David marin]

Yes

[Netduma Liam]

5 hours ago, David marin said:

Yes

Can you double check the WAN IP of the R2 is still the same as the IP in the Sagecom DMZ? It may have changed since and you'll need to put the new IP in there. I'd also suggest reserving the IP address of the R2 from the Sagecom interface so it doesn't change in future.

[David marin]

Okay I will try after work . But DMZ is now disable as you recommend 

[Netduma Liam]

1 hour ago, David marin said:

Okay I will try after work . But DMZ is now disable as you recommend 

To be clear, only disable the DMZ for the PC on the R2. Keep the DMZ enabled for the WAN IP of the R2 on the Sagecom.

[David marin]

I pass you some screenshots

[Netduma Fraser]

When you did port forwarding, what were the rules you were using?

[David marin]