gearsniper550 Posted September 23, 2022 Posted September 23, 2022 i click on geo filter and it just loads over and over and says this rapp is not loaded yet, please try again
Administrators Netduma Fraser Posted September 23, 2022 Administrators Posted September 23, 2022 On the System Information page, click the icon on the Rapp Panel, set the retries to 5, reboot from the interface, wait 2 minutes then access and see if it loads correctly
Broy34 Posted October 17, 2022 Posted October 17, 2022 I would greatly appreciate some help. I’ve been all over this forum today. I’ve tried everything. I cannot do the long process that mentions having to plug it in with Ethernet because my computer doesn’t have the Ethernet port so I’m not able to re upload the firmware. I’ve done the 5 times reboot thing, I’ve rebooted it and waited two minutes. I’ve factory reset it by holding the back.
Netduma Liam Posted October 18, 2022 Posted October 18, 2022 10 hours ago, Broy34 said: I would greatly appreciate some help. I’ve been all over this forum today. I’ve tried everything. I cannot do the long process that mentions having to plug it in with Ethernet because my computer doesn’t have the Ethernet port so I’m not able to re upload the firmware. I’ve done the 5 times reboot thing, I’ve rebooted it and waited two minutes. I’ve factory reset it by holding the back. Welcome to the forum! Could you please create a new topic in the below sub-forum and include as much detail as you can regarding the exact problem you're having and what you've done so far to troubleshoot it. https://forum.netduma.com/forum/87-dumaos-on-netgear-nighthawk-support/
Recommended Posts
Archived
This topic is now archived and is closed to further replies.