pkayyy Posted May 27, 2021 Share Posted May 27, 2021 I just purchased the XR1000 Netgear Nighthawk today, I noticed i made a small mistake in the naming convention of my wifi, so i wanted to make a change, after doing so, the router rebooted and wifi came back on, however i could no longer connect to the DUMAOS Software to continue my configuration process i was going through, I just get this error, tried on multiple browsers and devices. Link to comment Share on other sites More sharing options...
Newfie Posted May 27, 2021 Share Posted May 27, 2021 Hi if this was on the setup and you can’t connect via wired or wireless it might just be a little gremlin in the system. If so I would use the rear pinhole method to reset and start again. Simply hold the reset in for around 20 seconds, release and allow the router to boot up. After that you should be able to access the router and proceed with setting it up again. Link to comment Share on other sites More sharing options...
Netduma Liam Posted May 27, 2021 Share Posted May 27, 2021 Thanks @Newfie! Welcome to the forum @pkayyy! You could also try going to routerlogin.net in your browser and see if this changes matters, as Newfie said it could just be a little gremlin giving you grief! Let us know how you get on. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.