Wizdom Posted March 20, 2021 Author Share Posted March 20, 2021 I tried with another computer but same results. It started this morning when I tried logging into dumaos and got asked for a username and pw but I never wrote it down so I had to do a factory reset Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted March 21, 2021 Administrators Share Posted March 21, 2021 Ah so not the VPN then. On the other PC can you open command prompt and type ipconfig and press enter, then post the results here please. Then reboot the router to try and get internet back, if that doesn't work you'll need to do a reset. Link to comment Share on other sites More sharing options...
Wizdom Posted March 21, 2021 Author Share Posted March 21, 2021 I tried doing a facotry reset but when I try logging in its asking for a username and password Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted March 21, 2021 Administrators Share Posted March 21, 2021 Username = admin Password = password Try that please and see if it works Link to comment Share on other sites More sharing options...
Wizdom Posted March 22, 2021 Author Share Posted March 22, 2021 no it doesnt Link to comment Share on other sites More sharing options...
Netduma Liam Posted March 22, 2021 Share Posted March 22, 2021 13 hours ago, Wizdom said: no it doesnt Your R2 will revert back to those details after a reset, how did you perform the factory reset? Link to comment Share on other sites More sharing options...
Wizdom Posted March 22, 2021 Author Share Posted March 22, 2021 I followed the steps below https://www.router-reset.com/default-password-ip-list/Netduma Link to comment Share on other sites More sharing options...
Netduma Liam Posted March 23, 2021 Share Posted March 23, 2021 17 hours ago, Wizdom said: I followed the steps below https://www.router-reset.com/default-password-ip-list/Netduma We strongly advise you don't perform a 30-30-30 reset, this can brick a router. Instead, simply hold the reset pin on the back of the R2 for thirty seconds, release it and wait for a few minutes while it resets. You will then be greeted with the initial setup page when you go to the interface. Link to comment Share on other sites More sharing options...
Wizdom Posted March 23, 2021 Author Share Posted March 23, 2021 got it working again thank you! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.