Congestion control auto setup not saving settings

[Nigel]

When I run the auto setup for the congestion control, it goes through the cycle but does not save the settings when finished. Is there anything you can do thanks.

 

[Netduma Fraser]

What do mean it doesn't save it? There is an option at the bottom for you to click save settings, do you have that available?

[R3my7]

On 9/3/2020 at 4:00 PM, Netduma Fraser said:

What do mean it doesn't save it? There is an option at the bottom for you to click save settings, do you have that available?

Whenever I run my auto setup. I have the screen pop up that runs the test, but I can't find save settings anywhere.

[Nigel]

The save setting is there it just when you press save it does nothing

[Guest Killhippie]

7 hours ago, Nigel said:

The save setting is there it just when you press save it does nothing

Did you do a factory reset and clear your bowser cache? Try the browser cache first, if not do a factory reset and start again.

[Netduma Fraser]

15 hours ago, R3my7 said:

Whenever I run my auto setup. I have the screen pop up that runs the test, but I can't find save settings anywhere.

Use the browser zoom to zoom out slightly, do you then see it? This should be fixed in a future firmware.

9 hours ago, Nigel said:

The save setting is there it just when you press save it does nothing

As above try that and let us know if it works.

[Nigel]

I can see the "save settings" button but when I press it it does not save the setting that the auto setting result lands on 

[Netduma Fraser]

18 minutes ago, Nigel said:

I can see the "save settings" button but when I press it it does not save the setting that the auto setting result lands on 

Is this after clearing the web browser cache/cookies? What firmware version are you on and what web browser/device are you using to access it?