Jump to content

Netduma cuts speed in half?


Recommended Posts

Before using netduma, and by hardwiring my modem into my pc. My speed are ususally 90 down/12 up. Netduma has cut those speeds down to anywhere from 25-50 down/ 4-8 up. I have tried disabling ipv6 as the forum suggests and other that the slow internet FAQ post suggested to no avail. Help?

Link to comment
Share on other sites

  • Administrators

Do the following:

  • Enter your speeds into bandwidth settings
  • Reactive Algorithm
  • 100% anti-flood
  • Share excess enabled
  • Reset device prioritisation & apply
  • Disable IPv6 in WAN, LAN & misc
  • Disable deep packet in misc
  • Do a wired speed test from a PC
  • Enable turbo mode (only if you still can't achieve full speeds after doing everything else)
Link to comment
Share on other sites

  • Administrators

Post in the 1 on 1 section and I can take a quick look at your settings. One thing though, make sure you're not putting your streaming PC through the hyper traffic as that may cause issues like this - it is only meant for low latency traffic

Link to comment
Share on other sites

Post in the 1 on 1 section and I can take a quick look at your settings. One thing though, make sure you're not putting your streaming PC through the hyper traffic as that may cause issues like this - it is only meant for low latency traffic

Through the hyper traffic? Could you show me where that is?

Link to comment
Share on other sites

  • Administrators

If you have nothing in there that is fine. Just a thought that could be an issue. 

 

Can put your console in there yes if you're not streaming from it/downloading a lot etc. 

 

In the screenshots in your 1 on 1 thread you have deep packet processing ticked, that needs to be unticked. Should have full speeds after that if you followed everything else i mentioned above

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...