SendNukes Posted September 8, 2020 Posted September 8, 2020 sometimes I have ipv6 access and sometimes it just detects ipv4. Ipv6 is enabled on the netduma r2 I've went straight to modem to see if it was isp but I had ipv6. Whats the issue?
Administrators Netduma Fraser Posted September 9, 2020 Administrators Posted September 9, 2020 Are you seeing this on all your devices? Do you have IPv6 enabled in both WAN/LAN? If you toggle IPv6 off, apply then on and apply do you get an IPv6 address again?
SendNukes Posted September 10, 2020 Author Posted September 10, 2020 Yea I tried that first. Didn't work. Although later on, ipv6 was all good again. To clarify: without the netduma r2, ipv6 stays active. But I also have issue with the netduma creating packet loss. Also has an issue with providing signal to any device not hard wired in
Administrators Netduma Fraser Posted September 10, 2020 Administrators Posted September 10, 2020 Has it stayed active since then? I responded to your other topic. We are working on improving the WiFi right now so we should have a solution soon.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.