SomDeVIL Posted June 23, 2018 Share Posted June 23, 2018 Since the latest firmware V2.3.2.22 I've consistently been showing in COD WW2 as NAT Type Moderate and previously I was NAT Type Open. XR500 is in DMZ. UPnP enabled and populating port map table. Port 3074 to the correct IP address of the console. No error messages. Link to comment Share on other sites More sharing options...
Administrators Netduma Admin Posted June 23, 2018 Administrators Share Posted June 23, 2018 Your setup sounds good. Make sure you hard reset your console just in case the game isn’t getting confused. What’s your NAT status on the console? (Not the actual game) You could try adding manual port forwarding rules or putting your XBOX in a DMZ too, but if UPNP is enabled you shouldn’t be having any problems. SomDeVIL 1 Link to comment Share on other sites More sharing options...
SomDeVIL Posted June 24, 2018 Author Share Posted June 24, 2018 Your setup sounds good. Make sure you hard reset your console just in case the game isn’t getting confused. What’s your NAT status on the console? (Not the actual game) You could try adding manual port forwarding rules or putting your XBOX in a DMZ too, but if UPNP is enabled you shouldn’t be having any problems. I hope you meant hard reboot. I don't want to reset (and erase) my console Anyways, I thought I had done a hard reboot already but I must've just did a simple reboot. Hard reboot seems to have fixed it. NAT Type 2/Open again. Thanks for the response and suggestion! Netduma Fraser 1 Link to comment Share on other sites More sharing options...
Recommended Posts