XR1000 stuck at 1200mbs mode even though I picked 4800mbs mode

[Anubis2020]

Channel width is 160mhz, confirmed using wifi analyzer but then the router reports that its running on 1200mbs mode?

screenshots attached

 

[Netduma Fraser]

Reboot the router then check again, has it changed?

[Anubis2020]

Already did that, same thing

[Netduma Fraser]

So it's all working as expected, you're just concerned with the aesthetic of it showing a lower value when it should show the higher value?

[Anubis2020]

2 hours ago, Netduma Fraser said:

So it's all working as expected, you're just concerned with the aesthetic of it showing a lower value when it should show the higher value?

Yupe, this is not a new router, many updates for it have been released thats why i was confused and just wanted to make sure its just a bug and every thing is fine.

confusing 🥴

[Netduma Fraser]

If it's all working correctly you can just ignore it. It's from the NG side so I don't know what they may have changed to have it report incorrectly