xr1000 ipv6 keeps breaking

[FrankM530]

so ever since the new update XR1000 1.0.0.72_1.0.62  

the ipv6 started to break again on the router is this a known issue or is my router just not working properly ?

[Netduma Fraser]

IPv6 isn't a setting we've made/control so it'll be hard for us to answer this one - break in what sense?

[FrankM530]

it will work for about 15 minutes after it is set and then after no device connects to ipv6 address this just started happening after this hotfix update .

 

[Netduma Fraser]

Can you provide a screenshot of the IPv6 page, how you have that setup please?

The hotfix just had security updates in so surprising it would cause an issue like that

[FrankM530]

It is set to dhcp and cloudflare dns ive also tried comcast dns but no matter what it stops working.

 

[Netduma Fraser]

That all looks fine from what I can see, can you grab the logs from the System Information page when it happens again please and I can take a look

[FrankM530]

log-1716678606189.txt

[Netduma Fraser]

In LAN Settings, set the DHCP range to start at .50, then assign reserved IP addresses to devices between .2 & .49 so they're out of the DHCP range, apply, reboot from the interface, wait 2 minutes and see if that stops the disconnects.

[FrankM530]

yea I tried that and still disconnects.

 

[Netduma Fraser]

Now disable DHCP/use the router as a DHCP server and see if it continues please

[FrankM530]

I tried that but nothing would connect. Idk its shows its setup but no device has ipv6.

[Netduma Fraser]

Did you set the reserved IPs? If you didn't then disabling DHCP would prevent devices connecting. Make sure you've reserved the IPs for devices, reboot the router, disable DHCP then check again.

[FrankM530]

Yea i have all the devices on reserved ips and for some reason disabling dhcp makes it to where nothing connects unless its hard wired . And even then devices like firecube wont detect the internet even tho they are hard wired.

[Netduma Fraser]

Ah did you give them reserved IPs while they were connected via ethernet and then connected the devices via WiFi?

[FrankM530]

No they all remained in the same type of connection from when i gave the reserved ip

[FrankM530]

I did a factory reset via router button and setup and havent had a issue so far 24 hrs now I tried disabling dhcp after setting a reserved ip but some devices like ring and camera devices wont connect including andriod devices will connect but redisconect non stop until i set up static ip on the device setting but ring and camera dont have that option so i had to enable dhcp again.