Savi Posted November 21, 2023 Share Posted November 21, 2023 My internet speed on connection benchmark shows around 300GB but on speedtest.net shows around 700-800 Its half the difference how can I correct it my main modem is on dmz mode qos is disbaled Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted November 21, 2023 Administrators Share Posted November 21, 2023 That's fine, it uses different servers so it won't always show the correct results, it depends on your proximity to the servers and the routing to them. As you can see from speedtest.net the router isn't limiting you to the speeds shown on Benchmark so you can ignore them. Link to comment Share on other sites More sharing options...
Savi Posted November 21, 2023 Author Share Posted November 21, 2023 I am not getting NAT type open in MW 3. I have put my main modem on DMZ and still the NAT is Moderate how do I change it any suggestions Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted November 21, 2023 Administrators Share Posted November 21, 2023 Just to clarify, it's the WAN IP of the R2 (found on the System Information page) that's in the ISP modem/router DMZ? The Geo-Filter can cause a misreading of the NAT status so close down the game/client completely, disable the Geo-Filter, reboot the console/PC then launch the game, does it appear open then? Link to comment Share on other sites More sharing options...
Savi Posted November 22, 2023 Author Share Posted November 22, 2023 Yes it is the WAN Ip of R2 in Main modem DMZ I did each of these things its still moderate😔 Link to comment Share on other sites More sharing options...
dubNinja Posted November 22, 2023 Share Posted November 22, 2023 6 hours ago, Savi said: Yes it is the WAN Ip of R2 in Main modem DMZ I did each of these things its still moderate😔 I'm having the same issue. I don't think it's possible to have an open NAT with Geo filtering. Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted November 23, 2023 Administrators Share Posted November 23, 2023 If you take the R2 out of the equation so you connect directly to the ISP modem/router do you get an Open NAT? Link to comment Share on other sites More sharing options...
Recommended Posts