Netduma keeps disconnecting

[Mikeysacks]

What's going on y'all?  Set up my duma and it keeps disconnecting I tried rebooting it and still nothing.  First time it happened I was able to log back into the router, this morning in a rush I rebooted the modem, mesh system and duma and nothing.  House has been without internet all day while I'm at work.  Any help would much appreciate it.  

[Netduma Fraser]

It may be it's gone back to the Setup Wizard, if you access does that appear and if so once complete do you have internet again?

[Mikeysacks]

I can't access it at all.  I tried on computer  dumaos/  also 192.168.77.1.  I tried wifi on cell and nothing 

[Mikeysacks]

OK, I'm able to get back in now.  Any recommendations on what can be wrong?  I have the deco tp link mesh system and there in AP mode.  

[Netduma Fraser]

Do you know what firmware version you're on currently? It may be worth applying for Early Access as that may be more stable for you: https://forum.netduma.com/topic/39415-introducing-early-access/

In the meantime, in LAN Settings, set the DHCP range to start at .50, then assign reserved IP addresses to devices between .2 & .49 so they're out of the DHCP range, apply, reboot from the interface, wait 2 minutes and see if that stops the disconnects.

[Mikeysacks]

The firmware I am currently on is 3.3.280

 

OK so under setting I clicked dhcp.

Range min .50

Then on the devices check reserved ip box and give them a number from .2 - 49 correct? 

[Mikeysacks]

Annnnnd now I can't get on the Xbox.  Wtf!!!! 

 

[Netduma Fraser]

On 7/19/2023 at 12:45 AM, Mikeysacks said:

The firmware I am currently on is 3.3.280

 

OK so under setting I clicked dhcp.

Range min .50

Then on the devices check reserved ip box and give them a number from .2 - 49 correct? 

Yes that's correct, I've given you Early Access so upgrade to that, do the same DHCP steps and see if it's more stable then:

https://forum.netduma.com/forum/144-netduma-r2-early-access/