XR500 - Not getting correct speeds on QOS.

[TeK]

Is this effectively bottlenecking what is being put out on my network. I have just 4 devices connected at the minute to my network with an even split in the congestion control tab.

 am getting 480 Mb download and when i speedtest each device individualy it gets around 120MB. 

 

This is the Speed that I have after I ran the wizard on initial setup. 

The speed after I ran auto detect on QOS. 

My benchmark. 

[Netduma Fraser]

Hey, welcome to the forum!

Don't worry about the speeds you're seeing there necessarily, they use different speed test servers than you may normally use, just make sure to enter manually the speeds you expect. Then connect ALL devices to the XR, any devices upstream i.e. connected to the ISP modem/router can pull bandwidth away from devices. Once you've done that do a wired speedtest.net test from a PC connected to the XR, what do you get?

[TeK]

28 minutes ago, Netduma Fraser said:

Hey, welcome to the forum!

Don't worry about the speeds you're seeing there necessarily, they use different speed test servers than you may normally use, just make sure to enter manually the speeds you expect. Then connect ALL devices to the XR, any devices upstream i.e. connected to the ISP modem/router can pull bandwidth away from devices. Once you've done that do a wired speedtest.net test from a PC connected to the XR, what do you get?

Hi Fraser, Thanks for the response. When I have multiple devices connected to the XR500 and have done speedtests on Speedtest.net. I do get my advertised speeds, I was just worried that my speeds were being tanked by congestion control. Thanks for clearing it up. 

[Netduma Fraser]

Ahh that's good to hear, no worries at all!