rjaaayyy

Xbox was not added to geo filter, it still didn’t work. The nat filtering was already on open.

I am on xr500, V2.3.3.134 It still stopped on several games after disabling qos.

Yes the installation stops and when I resume it just stops again. It isn’t consistent at where it stops, and it’s more than 1 game. It’s been in bridge mode to a Shaw modem xb6 I believe.

I have the installation stopped on my Xbox when I’m trying to install games or update games. I have done all troubleshooting steps on the Xbox. I even got a new Xbox. Problem still persists. I believe it’s my networking, because it installed just fine elsewhere. Any idea whats stopping them?

No there wasn’t. This time I did just those 2 and left the others unchecked.

What do you mean? I currently have Enable LAN/WAN packet capture checked. Aswell as Start debug log capture when boot up checked only.

What is going on why does none of the solutions work lol. Very frustrated

Only start debug log capture when boot up was checked. I had to enable LAN/WAN packet capture to use usb. The rest were unchecked.

No there isn’t.

Yes it was in, couldn’t press anything on the page when it disconnected though.

When I pressed save debug log when it happened, the page goes blank and says IP of the page can’t be found. So it doesn’t even save it I think.

It occurred again. What do I do now?

Like this and wait until disconnects?? How many should I have check marked.

It still did not allow me to get into it when I tried.

Without internet no, just says http://192.168.1.1/ is unreachable when I just type that IP in.

I simply cannot get to it, without internet it says site can’t be reached www.router login.nets server IP address could not be found. Wired and wireless samething.

I can’t access the interface without internet.

I did, it still did it once that day. Getting there I guess. Haha

How do I do that? The Xbox has that IP, how can I change that?

Yes

Doesn’t work either.

uh im not sure, Its a shaw modem thats been bridged for the xr500.

Xr500 router. I click default dmz server and what do I put as the IP the consoles IP?

It does not