Jump to content

wolfeman

Members
  • Content Count

    36
  • Joined

  • Last visited

Everything posted by wolfeman

  1. Yes under WAN settings where I have autodetect selected and it is defaulting to DHCP there is a drop down bar and some options are either just Transparent bridging(TB)- or TB 0/32, TB 8/35 or TB 0/35. I did some googling in the past as to which bridge mode to try and boy did that open up a can of worms. I believe I crashed my whole internet after switching to the bridge modes and made a post on this forum about it. I cant really remember how I fixed it or even what caused my issues. I am not very savvy when it comes to internet technical things. I have definitely followed the optimal settings guide more than once. As for the age of my Duma, I don't think it's that old. I could always provide a serial number but I don't think its more that 3 years old. Could be though.... lol
  2. Alright, here are my ISP settings. I will just go down the tabs in order in the advanced settings. DHCP: Enabled IPv6 Lan: Disabled DHCP Reservation: Enabled and auto dhcp enabled WAN settings: ISP protocol (auto select) Selected-DHCP DNS host mapping: My isp router is there centurylink technicolor c2000T Dynamic DNS: Disabled Dynamic routing: Disabled Static Routing: IPv4 selected, nothing inputed No ports forwarded DMZ: Enabled with DUMA WAN IPv4 Firewall: disabled IPv6 Firewall: Enabled, block traffic in, allow traffic out NAT: Enabled UPNP: Enabled; UPnP NAT-T state Enabled. There is a device in the NAT-T list. I also have the wireless function off to allow devices to be used by the DUMA.
  3. I can turn upnp on again and see what happens. I have tried so many things that I cannot remember why I do stuff. haha Yes I have the Duma WAN IP in the isp router DMZ. I gotta run out for a bit, when I get a chance I will go into my ISP router and give you my current settings there. Thank you for your time so far.
  4. My other settings are as follows. LAN: ipv6 off DHCP on UpnP off Port forward off, but I have isp router in DMZ WAN: ipv6 off, dhcp on Anti Buffer bloat- when high priority detected. 70/70 (not sure why I cannot find the tab that has preemptive ect...) I know I set that to whatever Jack recommended.
  5. Ok yes I found share excess under the QoS tab. It is checked for both I believe
  6. All my bandwidth is allocated evenly at the moment. I am not sure where to find the share Excess option.
  7. not sure why my photos are covering the text? Hope its not like that on everyones screen.
  8. Hello, I have had a few discussions in forums over the time i've had Netduma. Jack plus others have been suggesting fixes and optimal settings and I appreciate all their insight. However, months ago I just gave up and unplugged my Duma from my ps4 and connected back to my ISP router/modem combo because I get better connection MBPS from there. I love being able to geo filter etc which is why I purchased Duma, I play mostly CoD and wanted to eliminate the laggy play as much as possible. I followed the optimal setting and tweaked everything to advice given but my duma is basically halfing my internet speed or worse. I cannot figure out why? The only reason I can think of is that im running 70/70 DL-UPL filter as suggested for gameplay. I don't think it should be messing with my speed that much if its the optimal setting.... I am attaching some photos of my speed test today, you can see in the background that my yellow ethernet cable is hooked up to Duma in two and my ISP for other two ( the higher speeds) The speed difference is significant. My speed package is 25mbps from centurylink. Maybe someday I will get to enjoy the wonders of dumaos. lol
  9. I tried to set up pppoe and then switched my isp back to bridge. However i dont think I had the correct name and password, as I really dont know anything about that. I totally understand they are busy. Well my issue was that after always having open NAT, it all of a sudden switched to moderate in black ops 4. I have always had the wireless off plus optimal settings recommended by Jack etc. I have my router in DMZ with the WAN address of netduma, yet for some reason I cant get open nat anymore, with dmz or port forwarding. Thus, I said screw it and im going to try and bridge my combo router......which resulted in a whole day of nonsense lol Id rather not bother the Devs either. Oh and how the heck do I find out my PPoE password. It is hidden in my isp GUI. Is that a password I need to call them for?
  10. Hello, I am requesting a 1 on 1 due to the fact that my isp (centurylink) told me to provide encoding, vpi/vci and v-lan to NetDuma techs in order to successfully bridge my router as a modem. I did not want to post my info publicly incase its sensitive info. I spend 5 hrs so far today on the phone with isp techs troubleshooting my issue. Everytime I try to put my isp modem into transparent bridge mode 8/35, my internet connection gets blocked. My isp techs eventually deducted that the netduma router must be somehow blocking my internet everytime I do a bridge. Something about how once its bridged the gaming router is now the provider of the internet, etc. Does this make any sense? Should I be bridging my isp router/modem combo? My set up has worked fine previously by just turning isp wifi off and only connecting duma via WAN but I feel I still have issues and figured having a bridged combo would just make everything run smoother. Thank you for any help here. I do currently have the info to provide you about encoding etc.
  11. Nat type mysteriously back to moderate in game, yet I have not even played since this last post. Did not change any settings. Netduma still in DMZ. Weird that after network settings always saying open that after I tweaked a couple things, yet put them back as they were, that I now keep having a moderate setting in game. Frustrating.
  12. Alright so I got my open back. I turned off upnp in newtwork settings tab on duma. Then I power cycled my isp router and restarted game. open NAT. But that still leaves me with the question of what the heck is the client mismatch, tty host error we keep getting??!!
  13. If I log into my ISP router upnp is on and upnp nat-t is on. ( these have always been on as I did not change anything) There is a long list of ports (8 of them) associated with my isp router ip address in a box below named upnp nat-t list and has an option to remove them. for example. device-unkown ip adress- xxx.xxx.xx.xx port range- 9308 protocol- udp
  14. Hello, Within the last few hours my nat type in game changed and always says moderate now no matter what I do. I have had an open nat type since day one of the game, I have had the duma wan ip address in my DMZ this whole time. So I started messing with some settings because my friend and I were trying to get into a zombies lobby together but I kept getting an error saying client mismatch......check tty host something something.... I didnt mess with too much, I first just deleted my device, turned to spectate etc. no help. He is allowed in my ip list already so shouldn't matter. I then just tried to see if it was because of duma itself, so I unplugged the wan/lan from duma and plugge directly into my ISP router. no change still client mismatch error. So then I hooked duma back up, power cycled it and started to look at possible things to change. I did check the reserved ip box and put the end of my ps4 ip into the dhcp under the network settings tab and press save, but i reverted back to how it was. I also turned upnp on and off then on again. It was off though this whole time if I remember correctly, I only turned upnp on and left it now after i noticed moderate nat, because dumaOS nat guide said to have it on. But no matter what I do I cant get an open nat now.. tried dmz my ps4 ip and the duma ip but not both dmz at same time ( although only the duma was dmz when I had open). I tried port forwarding the activision cod ports in the duma port forward tab, I did not port forward on my isp yet. ( although I never had ports forwarded before today and always had open nat) I even open the game with device deleted from gio filter and its still moderate, i tried in spectating and with strict mode off. I don't get why it turned moderate and why the heck i cant get open again after trying all that. Any suggestions on what to do to get back to my normal open nat type??????
  15. I have the same issue in eastern US time zone. I have my filter set on a 1000 mile radius filter mode strict mode auto ping Only peer connections i'm getting 1200+ pings when I finally find a match after about 5 mins, either that or it kicks me back to main menu. I have followed all optimal settings guides and previous advice from my inquiries. I have not tried the flushing thing yet but I would think the filter should work as intended and us not have to constantly play with it just to get a decent connection.
  16. I do understand that there is not much you can do when it comes to improving ping, as its all proximity based from what I know. However, I would like to be optimizing the QoS and any other settings in order to get the best/fastest connection possible. As i'm sure everyone else here is trying to do. haha
  17. Hello, I was wondering what the optimal DumaOS setting are for BO4? Should I open certain ports in the device priority section of QoS or in the port forward tab under network settings? I have a 21ish ping when I connect my computer directly to my isp lan, but in game it says my ping is anywhere from 90-130 all the time. I followed the general optimal set up for OS, I keep bufferbloat at 70% etc. Any and all advice will be great. Thank you
  18. Jack, Got it fixed. I will keep you posted on my progress
  19. I just tried to upgrade to dumaOS by following the instruction in the email, but after the green box popped up saying now upgrading this can take 3 mins, I got a white box that popped up and said your connection is not secure please log in. It wanted my username and password, however, I do not know my username and password. It is always automatically logged in and its been forever since I set it up. I tried my username and password for this forum but that did not work. I tried my log in info for the wifi, no luck. I know what passwords I usually use but I don't recall setting a username. I pressed cancel and now I cant access anything until I log in. When I tried to click tabs the screen went white and said directory doesn't exist. So I refreshed the page and now it wants log in again. I also just tried a hard reset on my router but all that did is reset the wifi password. How do I find out what the username and password is to access the actual interface after I type in the ip address or http://r1? Please help!"
  20. Jack, I followed the instructions for upgrade but I got a box that popped up and said your connection is not secure please log in. It wanted my username and password, however, I do not know my username and password. It is always automatically logged in and its been forever since I set it up. I tried my username and password for this forum but that did not work. I pressed cancel and now I cant access anything until I log in. When I tried to click tabs the screen went white and said directory doesn't exist. So I refreshed the page and now it wants log in again. Please help!
  21. Thank you I was not aware of a new software update. After reading the email for DumaOs, I checked my current OS and it is r1 debug version 1.03.6h. That is ok to do the DumaOs upgrade without having to manually do it? I do not want to permanently break my router. Also, is there any eta on ping assist being developed? I think I use that for call of duty..... not sure though....I want to reduce lag as much as possible. Thanks again.
  22. Jack, I figured I would reply here so that there is a history of my issues. Today I returned home from a month vacation and my mother has been here watching the home. She complained of slow wifi. I decided to test some things. Speed test over wifi came back ping 319 and 2 mpbs. I then plugged my computer through ether and was getting 21 ping and 24mbps. I then decided to unplug the NetDuma to see if that was the wifi intererence, so I logged into my centurylink routet page and re-enabled wifi. I then re checked wifi speedtest and it came back 28 ping and 24mbps. So to me that says there is some issue with the duma's wifi signal.... What could be causing the netduma to output such a slow wifi connection? To refresh, I am running a centurylink ct2000 router with just the internet plugged to it and wifi disabled and the net duma in DMZ with all the other devices plugged directly yo NetDuma and all devices running off of NetDuma wifi signal as previously advised for set up and other inquiries. Thank you!!
×
×
  • Create New...