DeathRoll666

Hi, I'm having a big issue with .540 update. I'm unable to connect with the WiFi using 5Ghz/160 Mhz connection. Firmware .290 works without an issue. Any solutions ?

@cedric108Try to set Channel Width to 80 (5GHz - Advanced tab). I had issues with my Wifi speeds but that did the trick. Let me know it that helps You as well

Hi, after switching to the newest firmware I'm experiencing very low speeds using Wi-fi connection (2,4GHz and 5GHz). First screen shot shows 2.4 GHz , second 5GHz , thirds shows a router from my broadband provider. It's outrageous that I can have nearly full speed with Upload while Download remains very low (I pay for 900down and 100up). Before the update I was getting around 600 down and 100up using Netduma which was ok for my need, but having a quater of the speeds is not acceptable for me. I thought I'll revert the update and flashed older software but the problem remained the same. 
 
P.S - yes I've checked the WiFi channels congestion etc. Netduma used same settings and now it seems I can't have my old speeds.

I'll try this later on as I'm streaming currently, I'll let You know 👍🏻

Actually take the Hub out of bridge mode, then as you won't need PPPoE in the setup the reboot should be sufficient to get you internet and allow you to complete the wizard