LucKyGGTV

I have uploaded R2 version 3.3.501 I did a factory reset after the update. The best speeds now with the 2.4GHz & 5GHz mirror settings. Default settings: 2.4GHz : Channel 6 & 40MHz 5GHz: Channel 44 & 80MHz At the same time, my steamdeck shows a speed above 100mb. Whereas the iPhone ~ 15. It's much better, but still weak, and changing the wifi settings reverts to a maximum of 15mb on each device. For now, I'll have to settle for this, if anyone has any additional advice, I'd be glad to share it. Thank you for your help so far.

@Netduma Fraser I checked this on several phones and computers.

@Netduma Fraser I did as you wrote, the problem is still there. These are my results on the 2.4GHz network - 2 meters from R2: 5GHz -same distance:

@DARKNESS I have hybrid vpn turned off @Netduma Fraser Once it made it worse, other settings didn't make it better as it is. WiFi Scan: wlan0: BSS 54:db:a2:12:0c:c9(on wlan0) TSF: 1497523917196 usec (17d, 07:58:43) freq: 2462 beacon interval: 100 TUs capability: ESS (0x0411) signal: -67.00 dBm last seen: 460 ms ago SSID: TELKAB_WIFI_120cc8 RSN: * Version: 1 * Group cipher: CCMP * Pairwise ciphers: CCMP * Authentication suites: PSK * Capabilities: 1-PTKSA-RC 1-GTKSA-RC (0x0000) HT capabilities: Capabilities: 0x11ee HT20/HT40 SM Power Save disabled RX HT20 SGI RX HT40 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 4 usec (0x05) HT RX MCS rate indexes supported: 0-15, 32 HT TX MCS rate indexes are undefined HT operation: * primary channel: 11 * secondary channel offset: below * STA channel width: any BSS 54:db:a2:12:0a:49(on wlan0) TSF: 1295877470790 usec (14d, 23:57:57) freq: 2462 beacon interval: 100 TUs capability: ESS (0x0411) signal: -64.00 dBm last seen: 326 ms ago Information elements from Probe Response frame: SSID: TELKAB_WIFI_120a48 HT capabilities: Capabilities: 0x1ac HT20 SM Power Save disabled RX HT20 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes No DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 4 usec (0x05) HT RX MCS rate indexes supported: 0-15 HT TX MCS rate indexes are undefined HT operation: * primary channel: 11 * secondary channel offset: no secondary * STA channel width: 20 MHz RSN: * Version: 1 * Group cipher: CCMP * Pairwise ciphers: CCMP * Authentication suites: PSK * Capabilities: 1-PTKSA-RC 1-GTKSA-RC (0x0000) BSS 54:db:a2:03:db:f1(on wlan0) TSF: 1474184294792 usec (17d, 01:29:44) freq: 2462 beacon interval: 100 TUs capability: ESS (0x0411) signal: -73.00 dBm last seen: 309 ms ago SSID: TELKAB_WIFI_03dbf0 RSN: * Version: 1 * Group cipher: CCMP * Pairwise ciphers: CCMP * Authentication suites: PSK * Capabilities: 1-PTKSA-RC 1-GTKSA-RC (0x0000) HT capabilities: Capabilities: 0x11ee HT20/HT40 SM Power Save disabled RX HT20 SGI RX HT40 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 4 usec (0x05) HT RX MCS rate indexes supported: 0-15, 32 HT TX MCS rate indexes are undefined HT operation: * primary channel: 11 * secondary channel offset: above * STA channel width: any BSS 54:db:a2:03:df:51(on wlan0) TSF: 1240355226001 usec (14d, 08:32:35) freq: 2462 beacon interval: 100 TUs capability: ESS (0x0411) signal: -86.00 dBm last seen: 379 ms ago SSID: TELKAB_WIFI_03df50 RSN: * Version: 1 * Group cipher: CCMP * Pairwise ciphers: CCMP * Authentication suites: PSK * Capabilities: 1-PTKSA-RC 1-GTKSA-RC (0x0000) HT capabilities: Capabilities: 0x1ac HT20 SM Power Save disabled RX HT20 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes No DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 4 usec (0x05) HT RX MCS rate indexes supported: 0-15 HT TX MCS rate indexes are undefined HT operation: * primary channel: 11 * secondary channel offset: no secondary * STA channel width: 20 MHz wlan1: BSS 54:db:a2:12:0a:4a(on wlan1) TSF: 1295861208295 usec (14d, 23:57:41) freq: 5200 beacon interval: 100 TUs capability: ESS (0x0111) signal: -77.00 dBm last seen: 2730 ms ago Information elements from Probe Response frame: SSID: TELKAB_WIFI_5G_120a48 RSN: * Version: 1 * Group cipher: CCMP * Pairwise ciphers: CCMP * Authentication suites: PSK * Capabilities: 1-PTKSA-RC 1-GTKSA-RC MFP-capable (0x0080) * 0 PMKIDs * Group mgmt cipher suite: AES-128-CMAC HT capabilities: Capabilities: 0x1ef RX LDPC HT20/HT40 SM Power Save disabled RX HT20 SGI RX HT40 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes No DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 4 usec (0x05) HT RX MCS rate indexes supported: 0-15, 32 HT TX MCS rate indexes are undefined HT operation: * primary channel: 40 * secondary channel offset: below * STA channel width: any VHT capabilities: VHT Capabilities (0x33c179b1): Max MPDU length: 7991 Supported Channel Width: neither 160 nor 80+80 RX LDPC short GI (80 MHz) TX STBC SU Beamformer SU Beamformee +HTC-VHT RX antenna pattern consistency TX antenna pattern consistency VHT RX MCS set: 1 streams: MCS 0-9 2 streams: MCS 0-9 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT RX highest supported: 780 Mbps VHT TX MCS set: 1 streams: MCS 0-9 2 streams: MCS 0-9 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT TX highest supported: 780 Mbps VHT operation: * channel width: 1 (80 MHz) * center freq segment 1: 42 * center freq segment 2: 0 * VHT basic MCS set: 0xfffa BSS 54:db:a2:12:0c:ca(on wlan1) TSF: 1497517056068 usec (17d, 07:58:37) freq: 5500 beacon interval: 100 TUs capability: ESS (0x0111) signal: -85.00 dBm last seen: 2023 ms ago SSID: TELKAB_WIFI_5G_120cc8 RSN: * Version: 1 * Group cipher: CCMP * Pairwise ciphers: CCMP * Authentication suites: PSK * Capabilities: 1-PTKSA-RC 1-GTKSA-RC MFP-capable (0x0080) * 0 PMKIDs * Group mgmt cipher suite: AES-128-CMAC HT capabilities: Capabilities: 0x1ef RX LDPC HT20/HT40 SM Power Save disabled RX HT20 SGI RX HT40 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes No DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 4 usec (0x05) HT RX MCS rate indexes supported: 0-15, 32 HT TX MCS rate indexes are undefined HT operation: * primary channel: 100 * secondary channel offset: above * STA channel width: any VHT capabilities: VHT Capabilities (0x33c179b1): Max MPDU length: 7991 Supported Channel Width: neither 160 nor 80+80 RX LDPC short GI (80 MHz) TX STBC SU Beamformer SU Beamformee +HTC-VHT RX antenna pattern consistency TX antenna pattern consistency VHT RX MCS set: 1 streams: MCS 0-9 2 streams: MCS 0-9 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT RX highest supported: 780 Mbps VHT TX MCS set: 1 streams: MCS 0-9 2 streams: MCS 0-9 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT TX highest supported: 780 Mbps VHT operation: * channel width: 1 (80 MHz) * center freq segment 1: 106 * center freq segment 2: 0 * VHT basic MCS set: 0xfffa

@DARKNESS I might have worded it wrong, unfortunately I'm using a translator 😁 Fiber optic cable goes to my apartment, which is connected to Halny HL-4GMV3. My operator does not give access to it - it is blocked.I have R2 connected to it.Both have different WiFi networks configured.

I just don't understand why, every speedtest shows low speed. See link from speedtest by ookla: https://www.speedtest.net/result/i/5638492892 And below is a photo from the dumaos app on my iPhone. Only there is good speed.

1. Still to the same 2. Still to the same 3. Wooden cabinet 4. TV ~60cm up | PS5 ~100cm 5. Different antenna settings do nothing. The Wifi speed from the modem, which is in another room, in a wall enclosed by a metal box, is much faster than I am 10cm from r2. Combining 2.4GHz and 5GHz into one network also does nothing. Of course, this is not a problem of one device, but of all.

Helo, I have a 900/200mb fiber optic internet. I have a modem with R2 in addition to RJ45 cables. The cable to the PC comes out of the R2 and the speed is satisfactory (700mb+). Unfortunately, even if I put the phone on R2 to a maximum speed of 20mb. I have a division into 2.4GHz and 5GHz. It works the same on each. And I have the settings set to automatic. DumaOS: 3.3.280