steelrain-0725

Ok so I had to manually change the DNS to 8.8.8.8 for the router to allow me to change the range. It’s not letting me reserve # .2-49?

Ok so now setting seem to have changed while I was gone at work today bc it won’t let me change my ip range bc it’s telling me there is a conflict. And my wan ip changed itself. What am I doing wrong??

Ok, so just to clarify change the ip range to 192.168.2.50 ~ 192.168.2.254 & reserve ip address 192.168.2 ~ 192.168.2.49?

Currently it is not set for that ip range bc it wasn’t fixing the disconnects. my current LAN ip address range is 192.168.2 ~ 192.168.254. A slight update I replaced a network switch that was about 3 years old last night. The devices that were disconnecting were connected via that old switch.

just additional fyi on my setup, My fiber line comes into the house downstairs in my basement. The AT&T router has Wi-Fi turn off and is in pass through mode, & is connected to the XR1000 that is next to it. As I said earlier that my 2nd router aka access point that is upstairs is hardwired and plugged into the XR1000 as well. I just built the house so each room has ethernet plugs that run back to my basement where all my equipment is

After the latest firmware installed on XR1000, i keep looking connection with multiple and different devices on my home network. my log shows this lease change happening over and over again and it seems to also take place when my connection issues happen. yes i have factory reset after the firmware upgrade.(at least 3 times now). I even tried the new ip range that was suggested. I need help please.