goofygooberr7

Should I turn IPv6 off on by hub if there is an option ?

Fair enough . How do I do that just disable IPv6 . The whole time it’s been set up on Xbox it’s always said ipv4 only any way . And before turning IPv6 on netduma I was getting the same issue double Nat

Did 123 didn’t work . So enabled IPv6 on lan then rebooted r2 and console . Connection comes back but Nat is strict double Nat

And re enable ipv6 on lan and wan or just 1 ?

Disconnect what ? And delete Xbox from device manager then reconnect ?

Wired

1st pic is Nat test

I unchecked ipv6 on lan and wan then rebooted r2 . Then rebooted hub waited 2 mins then rebooted r2 waited 2 mins then restarted console . Then tested console and no internet . I’ve literally just redone the whole process and nothing

I unchecked ipv6 on lan and wan then rebooted r2 . Then rebooted hub waited 2 mins then rebooted r2 waited 2 mins then restarted console . Then tested console and no internet . I’ve literally just redone the whole process and nothing

Don’t that . Says error your internet isn’t set up when Nat test is completed

IPv6 unchecked on lan and wan . Can’t test internet connection speeds and Nat type can’t get a teredo ip address

Just did it and it and now it says . Can’t get a teredo ip address

None of that worked I did the last 1 but do not understand it . What do you want screenshots of ?