Jump to content

Jpostberg

R2 Early Access
  • Posts

    9
  • Joined

  • Last visited

Everything posted by Jpostberg

  1. I installed the early access version and did a factory reset. It still showing the 100mbps on the internet side. I uploaded a new image of the network items just incase. Thank y'all for all your help on this! Josh O.
  2. Here's the most updated one just to make sure.
  3. I have enabled remote access but I could not find a DMZ function on my modem. I have an Arris SB8200.
  4. Yep it is still showing the 100mbps
  5. Could it be that the port is bad or maybe a software issue? Josh O.
  6. Correct. I used the cable plugged into port 3 (1000mbps) and swapped it with the cable that was between the router and modem. That 1000mbps cable showed up as 100mbps for the internet port in Device Manager.
  7. I also tested the cable directly from the Modem to the PC and it does get the full 400mbps direct.
  8. I tried all the ethernet cables I have. All are ether Cat 6 or Cat 5e. What I did notice that the cables that are being identified as 1000mbps on the ports are showing up as 100mbps on the internet.
  9. Hi all, I bought my R2 about 3 months ago. I was getting around 400mbps when I first installed it but now I'm only getting right below 100mbps. When I plug my PC directly into my modem I will get the 400mbs. I've tried different ethernet cables and did a factory reset on both devices. Any help would be greatly appreciated! Josh O.
×
×
  • Create New...