Jump to content

VVrfXgep

Members
 View Profile  See their activity

  • Posts

    8

  • Joined

  • Last visited

Reputation

0 Neutral

See reputation activity

Basic Info

  • DumaOS Routers Owned
    Netduma R2
  1. VVrfXgep
    Apologies for the questions, so to confirm the security options you’re referring to are the Port scan protection and Syn flood protection found in the WAN section of network settings?
  2. VVrfXgep
    Any downsides of disabling protection? Just thinking that it’s already in DMZ on the hub etc…
  3. VVrfXgep
    Disable all firewall stuff on the SuperHub? Does that still apply if you’ve placed the R2 in DMZ?
  4. VVrfXgep
    No I turned off Wi Fi on the SuperHub and only connected the PC to the R2 so nothing was using the network other than my PC. I did read the warning about connections over 800 needing to be set manually etc… How do you recommend to set this, is there a particular speed test ?
  5. VVrfXgep
    So QOS disables along with any traffic control etc all off wired direct to the R2 I get 602 on the connection benchmark tool. On DSL Report I get 587 and via speed test I get 876. Now when connected direct to the SuperHub across all the speed testing sites I get between 850-900
  6. VVrfXgep
    Connected Wired for both. The SH gives me the higher speed test on most speed testing services. Then tested the R2 wired used their internal benchmarking tool which gave me 450-500 (changed a little after disabling UnP on the hub and QOS on the R2). But still considerable difference of speed
  7. VVrfXgep
    Ok, so not placing the SuperHub into modem mode and placing the R2 into DMZ works. Now the DL performance is pretty below what I get when hardwired into the SH. I usually get on avg 850-900 DL via the R2 via Ethernet I’m getting 400-500.
  8. VVrfXgep
    VVrfXgep changed their profile photo
  9. VVrfXgep
    Good Morning, I’ve recently purchased the R2, which by the way the service was absolutely rapid. It was in my hands in under 24 hours so great work on the delivery!! My ISP is Virgin Media, I have a SuperHub 4 with approx 940 down and 34 up. I’ve used the router in modem mode previously with an older Nighthawk router with no issues. I followed the instructions and connected everything, but it seems to not get a connection. It doesn’t generate any WLAN Info in system info I just shows “disconnected”. So I started again and followed the support article here making sure to allow the time for everything to initialise. but still no internet connection. I can hardwire direct to the SuperHub and get a connection. I’ve tried different cables and have ruled out this. SuperHub has been restored back to factory. The only think I haven’t don’t is flash the firmware on the R2 Any suggestions?
×
×
  • Create New...