goofygooberr7

Should I turn IPv6 off on by hub if there is an option ?

Fair enough . How do I do that just disable IPv6 . The whole time it’s been set up on Xbox it’s always said ipv4 only any way . And before turning IPv6 on netduma I was getting the same issue double Nat

Did 123 didn’t work . So enabled IPv6 on lan then rebooted r2 and console . Connection comes back but Nat is strict double Nat

And re enable ipv6 on lan and wan or just 1 ?

Disconnect what ? And delete Xbox from device manager then reconnect ?

Wired

1st pic is Nat test

I unchecked ipv6 on lan and wan then rebooted r2 . Then rebooted hub waited 2 mins then rebooted r2 waited 2 mins then restarted console . Then tested console and no internet . I’ve literally just redone the whole process and nothing

I unchecked ipv6 on lan and wan then rebooted r2 . Then rebooted hub waited 2 mins then rebooted r2 waited 2 mins then restarted console . Then tested console and no internet . I’ve literally just redone the whole process and nothing

Don’t that . Says error your internet isn’t set up when Nat test is completed

IPv6 unchecked on lan and wan . Can’t test internet connection speeds and Nat type can’t get a teredo ip address

Just did it and it and now it says . Can’t get a teredo ip address

None of that worked I did the last 1 but do not understand it . What do you want screenshots of ?

None of that worked I did the last 1 but do not understand it . What do you want screenshots of ?

Ok will I’ll let you know what happens thanks

Ok will I’ll let you know what happens thanks

Thanks for fast assistance . Yes I selected the r2 from device list Xbox series x And checked the status on Xbox series x . Download upload ping all working so I no it’s coming from the r2 because connection is slightly less for optimisation but Nat type is double and every time you re check it it stays the same even when restarting console

I haven’t use the netduma for a while . I’ve downloaded and installed latest firmware and setup correctly . I’ve gone into bt smart hub and enabled dmz option and selected netduma I’ve turned dmz on on netduma and put in console ip then rebooted bt smart hub and the rebooted netduma I keep getting strict Nat and double nat detected can someone tell me where I’m going wrong thanks