Search the Community
Showing results for tags 'performance'.
i would like to request a Automated Scheduled Reboot Feature added to the firmware capabilities for the Netgear XR500 Router. this feature is present on every other commercial router. Reason: the Router Performance sometimes Degrades over time or will not put through internet data. After Reboot the performance is top again or the internet data will be put through again.
How can I begin to troubleshoot this WiFi issue? It's increasing in frequency. I'm also noticing performance issue via wired connections as well. I see a lot of chatter on the forum about performance issues but no real concrete information. I've enabled allow remote access to tech support. Please take a look and advise. Now, I beg of you, should it be the product simply does not perform reliably, please please, PLEASE save us all the heartache and let's setup an RMA so I can return it. Both my wife & I work from home and we MUST have reliable WiFi even if I can no longer leverage the R2 itself. I beg of you. Thanks.
To everyone and anyone with ANY knowledge of DumaOS and the nighthawk XR300, help a fellow gearhead out! Brief backdrop of my current situation. Just purchased a CM700 modem and an XR300 pro gaming router to escape xfinitys stronghold and limitations. I’ve always had an issue with xfinitys hardware! All their modems/routers were “defective” which resulted in poor connection, multiple techs sent out to my home, constant device swaps. So I took the initiative to escape that misery. I was so anxious for my new hardware. Tried optimizing settings on DumaOS but no luck! I game on a PS4 Pro which is hardwired to the XR300. I live in Illinois. I mostly play Fortnite. ISP is Xfinity/150MBPs. My issue is, Geo filtering doesn’t work. Ping is high 30’s. Before I was getting 20-23. . When I try to configure settings via Geo Filter I’m shown “Nil 2.5” “Nil” with an adjustable bar. And under that “Nil” with a checkmark. I pinned geo filter to my dashboard to monitor my ping and it doesn’t measure my latency/ping, for example I should be shown “12ms”, instead it’ll indicate “Nil”, no actual values. Someone, anyone, help! I purchased these for the sake of optimizing performance! I feel like I’m not getting the most out of my new hardware! Also, if anyone can suggest specific configurations/settings, it would greatly be appreciated! This is all very new to me! Thank you to you all in advance! Looking forward to your replies! Ozzi