Search the Community
Showing results for tags 'lan'.
Found 4 results
Hi All, I have an XR450 as my only gateway/router (replaced FiOS gateway) connected directly to FiOS ONT on a 1GB connection. I have multiple Netgear switches and a LinkSys Velop mesh wifi network with 4 nodes. All 4 nodes are on a wired backhaul to a 16 port netgear switch (12/16 ports are in use.) The switch connects to the router. Pretty straight forward set up. Literally all devices show up as wired. My old FiOS router showed me which devices were actually wired and which were connected wirelessly. Is there any way to fix this in the XR450? Attached is the screenshot. As you can see, this view is not very helpful when trying to use the network map to manage devices as the network is not actually mapped correctly. Any suggestions would be appreciated!
To everyone and anyone with ANY knowledge of DumaOS and the nighthawk XR300, help a fellow gearhead out! Brief backdrop of my current situation. Just purchased a CM700 modem and an XR300 pro gaming router to escape xfinitys stronghold and limitations. I’ve always had an issue with xfinitys hardware! All their modems/routers were “defective” which resulted in poor connection, multiple techs sent out to my home, constant device swaps. So I took the initiative to escape that misery. I was so anxious for my new hardware. Tried optimizing settings on DumaOS but no luck! I game on a PS4 Pro which is hardwired to the XR300. I live in Illinois. I mostly play Fortnite. ISP is Xfinity/150MBPs. My issue is, Geo filtering doesn’t work. Ping is high 30’s. Before I was getting 20-23. . When I try to configure settings via Geo Filter I’m shown “Nil 2.5” “Nil” with an adjustable bar. And under that “Nil” with a checkmark. I pinned geo filter to my dashboard to monitor my ping and it doesn’t measure my latency/ping, for example I should be shown “12ms”, instead it’ll indicate “Nil”, no actual values. Someone, anyone, help! I purchased these for the sake of optimizing performance! I feel like I’m not getting the most out of my new hardware! Also, if anyone can suggest specific configurations/settings, it would greatly be appreciated! This is all very new to me! Thank you to you all in advance! Looking forward to your replies! Ozzi
One of the big reasons I bought the high end Nighthawk XR700 was its ability to see traffic stats in real time. A lot of times I'll have a LAN party and my connection will become worthless because one of the Xboxes or phones or something decides to hog all the bandwidth. I thought that with this router I could see who the bad apple was and block them, restoring order and peace to the land. Or if not block them, at least QOS would take over and not let any one device crush all traffic. However, I've discovered that the traffic monitor and QOS are only on Internet traffic. I can't see who's saturating the internal network. This has become an issue because right now my 5GHZ wifi network is only eeking out 1-3Mb/sec on speedtest, while my 2.4GHZ network is doing around 30Mb/sec (I have 300Mb down / 10Mb up). My wired network is still getting around 300Mb/sec download. So obviously there's a bad guy (or guys) on my 5GHZ wifi. But since none of the devices on that network are using Internet bandwidth, I can't see what's happening. Is there any way to see internal network stats? Did I misunderstand the router's capabilities? What about third party plugins or R-apps? I hate that I have this $500 rocket ship but can't reliably watch 4K videos in my living room... I'm open to any suggestions y'all might have.