Jump to content

Search the Community

Showing results for tags 'acesspoint'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • News & Community
    • News & Announcements
    • Feature Ideas & Improvements for DumaOS
    • Community Discussion
  • Support
    • Knowledge Base
    • Latest Firmwares
    • DumaOS on Netduma R2 Support
    • Telstra Game Optimiser Support
    • DumaOS on NETGEAR Nighthawk Support
    • DumaOS on Netduma R1 Support
    • DumaOS Mobile App Support
    • Original Netduma R1 Firmware Support
    • Call of Duty Support
    • New Games for the Geo-Filter
  • Duma Army Lounge
    • Gamer Talk
    • TechnoBabble
    • Off Topic
  • International Language Forums
    • NETDUMA Français
    • NETDUMA Español
    • NETDUMA Deutsch

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





DumaOS Routers Owned

TS Model

Website URL





PlayStation Network

Xbox Live

Nintendo Switch


Gamer Type

Favourite Genres

Connection Speed

Found 1 result

  1. Hi All, I've seen a few folks asking about what I'm doing but they're generally attaching a gaming console under the AP and not a PC, which is where I'm wanting to clarify using the DMZ or not... I have ISP problems, 1000 down / 30 up over coax but with signal noise and weakness in a large condo building (it's a long road getting them to address fixing it), so I'll show packet loss and ping spikes with moderate amounts of line load. For whatever reason, my Warzone hit detection is way happier with FQ-CODEL on a crappy DD-WRT router with bandwidth throttled down than it is on the XR1000. Even with similar Ping Plotter results via the XR1000 QoS, the hit detection and responsiveness are night and day for whatever reason with the DD-WRT's FQ-CODEL... Don't ask me why, but I promise it's not placebo. I'd like to use the XR1000 for wifi and routing for all devices other than my gaming PC, while having access to the geofilter for the (wired) PC but using the R6700v3's QoS setup... I'm going for is this... WAN -> XR1000 -> R6700v3 -> Gaming PC I was able to set this up no issue following this for the R6700v3 (https://wiki.dd-wrt.com/wiki/index.php/Wireless_access_point), except turning off the radios since it's only an AP for the gaming PC. However most of the comments I see for similar setups here say to put the R6300v3 into the XR1000's DMZ to avoid double nat... When I did that initially I was getting flooded with Remote Access attempts to my R6700v3... If this were a game console at the end of that router I wouldn't sweat it, but since it's a PC (albeit just an expensive COD box at this point), that seems a bit scary to see all those IP crawlers poking my AP. So do I not need to worry about this, as there's a second layer of protection at the DD-WRT router and those pings should be going nowhere, or should I never place that in the DMZ of the XR1000 since the end client is a PC? Is there any way to have the R6700v3 in the DMZ without it being broadcast for all those remote access attempts? Appreciate any info!
  • Create New...