tentrum

yes, PPPoE is OK. DumaOS is now installed and all work. The problem is that the factory reset does not erase the old LAN settings. It is absolutely necessary to put the old LAN address in IPV4 to be able to access the interface.

this address was the last one I had installed. I do not understand why the factory reset did not erase it

I succeeded using 192.168.3.1 as IPV4.

yes I closed the wifi. connect only one ethernet wire to the computer. No other wires in the router

In WAN settings. my router was programming with the PPPoE of my ISP. and the username and password have been changed when I change provider. But I did not change them in my Netduma.

The last picture we see the tabs of the 4 addresses that I tried I cleared the cache of google chrome. I connect my ethernet wire in port 2 of the router but nothing works.

I am no longer able to access the main menu of the router. I unplugged the router for 5 minutes. I kept the reset button and plugged in the router again. I waited for the router to make a beep. I am able to connect with the WIFI to the router or with an ethernet wire in port 4. I tried to access the main menu with the address (192.168.88.1), (http: // r1), (192.168. 1.1). I then change the properties of IPV4 for (192.168.88.1) . Nothing works. I send you the pictures of my IPCONFIG. IMG_2326.heic IMG_2325.heic IMG_2327.heic IMG_2328.heic IMG_2329.heic

Thank you, he work very good on version 1.03.06j and the host filtering work.

I was on version 1.03.06g and I could not access host filtering anymore. I downloaded version 1.03.06j to see if I could open the host filtering page again. It has installed the update and I can not access the router since that time. it no longer broadcasts wifi and even with an ethernet cable I can not open the address 192.168.88.1. is there a possibility to force a new firmware inside.