taylor

Jack, I really appreciate the fanatastic support. I’m fully aware that everything needs to be ruled out before any decisions are made. What router details do you require just all the info on the back told the r1? Anything else?

Netduma Jack, not sure where your last thread has gone, But, I tested as you asked.. When you power on the r1- the power light and act light come on with a beep, no port or WiFi lights flashed. The act light then goes out. When I walked past it this morning a good 18hrs later- it’s still powered on and port 2 and 3 lights were on... but nothing is plugged in. Anything else I need to try ? We don’t seem to be getting any where fast here

Okay, R1 isolated, powered and connected to laptop via port 2 on r1. WiFi disabled on laptop. Ipconfig shows all values... Media state : media disconnected connection-specific DNS suffix Tried with 2 other Ethernet cables and all the same result. Also no light flashing on port 2 of the r1 however port 1 light is on but there’s nothing connected to the r1 other than port 2- laptop. I noticed port 2 light was on this morning but nothing was plugged in to it. Only the power cable. Iv tried taking the power cable out and powered back up all lights show but no light is coming on when plugging in Ethernet cable in to any ports. ???

e38bimmerFN - thank you but what does FMAd mean ? netduma isolated from hh6 and connect to laptop via ethernet from port 2 on r1. wireless LAN adapter Wireless Network connection: media state : media disconnected wireless LAN adapter Wireless Network connection 2: wireless IPv4: 192.168.1.64 (this is what hh6 assigned to it when it was connected to it) subnet mask: 255.255.255.0 default gateway: 192.168.x.xxx iv tried the IPv4 address in the search bar but nothing happens.

won't reset, can't access interface and reset on back doesn't work. tried pressing it in multiple times now up to a minute and no lights flash

Currently having difficulties with the R1, its not coming up on any devices to access its wifi. Iv tried connecting via ethernet cable to laptop and says theres no IP doing the ifconfig test on cmd. iv tried release and renew but won't let me saying media disconnected. Usual setup is with hh6 and its usually sat in the DMZ. ISP>HH6>R1. on the HH6 when connected to R1 it showing as connected however the IP its assigned to doesn't work also. Iv tried to reset from the rear of the R1 but this has no effect, Iv held it in for up to a minute and nothing happens. If i pull the power cable from it and reinsert power comes on all lights flash but nothing - its like its completely unresponsive... any suggestions ?

Hi all, Well I'm having a nightmare with my netduma. It was working fine but i went to play with a few settings and now iv had to revert to my ISP home hub. Issue is now netduma can not find internet access so i can not load control panel, no other websites are working and neither is it working on any device. I can see when i connect it to my HH5 it registers there is a connection it gives it an IP address iv tried using this address but to no prevail. iv tried connecting R1 remotely to a laptop via ethernet and it won't load the control panel interface that way either. Iv tried resetting both but that has done nothing. need a huge help in hand resolving this issue please as I'm stumped and its so frustrating! ...to what is probably a simple fix...