R3M!X

Negative, Im on the XR500. The latest firmware.

Looks like this was resolved. Can you share what you did to fix the issue? I have the same problem.

There's a beta for the XR500?

Awesome thank you!

Does the XR500 also have the same issue in regards to xbox party chat? I'm thinking of buying the router again.

Oh RIP, Does the XR500 or R2 exceed that cap?

Does this fw version increase the speed cap of 1000mbps? I just upgraded my internet to 1200mbps. I can't go pass 1000mbps on an older fw.

I started from scratch again and apparently I missed one step last time I put the R1 on the modems DMZ. That step was rebooting both R1 and modern. That seemed to fix it and now I have an open NAT. Will monitor it for another day and see if the issue comes back. Thanks for all the help guys!!

Connection Type: DHCP via 802.1x

I've tried the R1 WAN and also the Xbox on the DMZ.

Long story short my ISP doesn't support bridge mode on their provided modem/router combo unit even though there is that option to put the unit into "transparent bridge" mode. I have followed the steps on here to put the consoles and R1 into the ISP provided unit in the DMZ. That still gives me double NAT on the wireless connected Xbox one X and wired Xbox series X. When I try to put the provided ISP modem to "transparent bridge" mode I have no internet connection at all. Can anyone with some knowledgeable experience assist me on this issue? My provided ISP modem/router combo unit : ARRIS NVG448B My router : Netduma R1 OS FW 2.1.3.292.1.3.29.1.3.29

It's been a while. Was using R1 and the XR500 and then ended up selling them for a mesh system, but I missed the Netduma OS features so I ended up buying a used R1 from someone. It's good to be back. Other routers are just not the same. Netduma for life! Lol

Can I get access to 3.0 please.

I clicked on the Hybrid VPN -VPN set up-entered my username and password credentials I got from my VPN provider under the "advance setings" and and then clicked connect but it fails. What did I miss? I know under the Configuration line I didn't enter anything because I wasn't sure what to enter on it. Can anyone help?

So I have another router that I have set up as a wireless bridge to the XR500. My problem Im coming across with is I can't seem to log into this second router so I can config and change the WIFI SSID. I read online that I should be able to identify the IP address of the second though my main router (XR500) DHCP list. I did that but the XR500 is not showing the IP address and just blank. The only reason I was able to identify the second router on the XR500 was through the MAC address. Can someone assist me and possibly be me some suggestions so I can resolve this? FYI, my devices that are connected to this second router can access the internet via Wifi and hardwired. This second router is connected to the XR500 via WIFI.