350mbps congestion control limitations

[cperry911]

hi i have netduma r1 and i get full download and upload with slider to 100% on download, bandwidth is set to 350/30

speed i actually get is 346/22. now with slider to 99% it download goes down to 146mbps. even if i set bandwidth to 600 so i can fine tune it better, at 99% its still only 146mbps. i did factory reset, reboot. none helped. im thinking there is a software limitation on the max antiflood will allow. anyone have any ideas on how to get this to work right?

[cperry911]

well after alot of speed tests and pinging at the same i get best latency at 140/19. so i quess it doesnt matter but i would like to know if this is a problem with my unit or software limitations.

[BIG__DOG]

have you enabled reactive in congestion control rather than pre-emptive? Also make sure you have cookies enabled and turbo mode!

 

 

 

set sliders to 50% and input your up and down speeds, when you apply do not allow router to make changes automatically. Reboot router and set sliders to 100% and you should get full speeds, then, when you reduce your sliders you should get a truer figure of your speeds, but it is not totally accurate.

 

 

 

 

 

[Netduma Fraser]

The only thing that I can think of that would cause this is using pre-emptive rather than the reactive algorithm on the Geo-Filter. Is bandwidth distribution reset and share excess enabled?