Jump to content

Switching connections from PS4 to PS3


Recommended Posts

Hello so i been playing BO3 On PS4 using wired connection for long time following all the recommended optimal setting and everything been working flawlessly. Recently i wanted to play BO2 hence making change of my connectiong from PS4 to PS3. ( I just plugged my ethernet from ps4 to ps3) Upon doing that I see my ps3 dont show up on device manager with its name, im guessing it shows as nameless device. However when i play BO2 it lags so much its not crisp at all like BO3 and PS4 are. What am i doing wrong? When i changed the connection do i need to change anything else? Do i need to update any setting because ifs clearly not the same. Please help

Link to comment
Share on other sites

To Edit the name from Nameless to Ps3 (or you may edit the name)

Go to Device Manager from the left and, then on the middle top click edit and then after this you should be able to change the name to PS3.

You might also want to change the default 'General purpose' to 'Game console'

 

When you change the connection you have to add it in the host filtering (I believe you did this already)

Make sure you pick the correct device, and then pick 'playstation network' as the service

-Make sure 'Enabled' is ticked so there is a green check mark

 

Now for the next part, this is what I do to achieve awesome connection

  1. On the left you should see profiles, click on that
  2. Change the 'General gaming' profile to 'Cod ultimate', go to the bottom middle and click on 'Load profile" (wait a few seconds or minutes so it automatically applies & changes the settings to optimize the filtering

Try a game out, it should really smooth the connection a lot now. (at least it did for me & also it may take a little while to find a game) for me, it takes like maybe 30 seconds to 1 minute to find a game

 

Small Tip; Some people may not know this, but make sure when you are about to join a match on black ops 2 and where it says 'playlists' press the button that makes it so you can go to the search preferences, on ps3 I believe it is the square button. Make it so it goes from 'normal' and change it to 'best'

Link to comment
Share on other sites

  • Netduma Staff

Hello so i been playing BO3 On PS4 using wired connection for long time following all the recommended optimal setting and everything been working flawlessly. Recently i wanted to play BO2 hence making change of my connectiong from PS4 to PS3. ( I just plugged my ethernet from ps4 to ps3) Upon doing that I see my ps3 dont show up on device manager with its name, im guessing it shows as nameless device. However when i play BO2 it lags so much its not crisp at all like BO3 and PS4 are. What am i doing wrong? When i changed the connection do i need to change anything else? Do i need to update any setting because ifs clearly not the same. Please help

 

Tai has given some great advice above - there's some more things we could try though. If you've switched console though you're still using the same Ethernet cable, it could be a NAT issue causing your gameplay to suffer. Check your NAT type on the PS3 in the Network settings and on the game menu. Ensure you have UPnP ticked on the Netduma in Settings > UPnP, and disable Port Forwarding.

 

Then, check your ping to the game using the Ping Graph. Let us know what your average ping looks like, and run an Internet  Diagnostics test on the Netduma to check your stats. Let us know the results :)

Link to comment
Share on other sites

Im trying to edit the nameless device to ps3 because i have about 4 nameless devices and i dont know which one is. However i cant add it because on left of the general purpose tab i have no other tab i can click to edit it. Thank you for all the help in advance

Link to comment
Share on other sites

I did everything you guys said but still lagging ugh. My average ping is between 32 to 40. And my diagnostic test results are ping good, jitter- exceptional, spikes- exceptional, packet loss- no loss. I also added the pa3 in host filtering loaded profile as ultimate cod. In my geo filter i have distance set as 2805km and ping assists at 50ms...not sure if its right. What else can i do? When im playing the game running feels smooth but gun fight is so hard going left to right or up and down it would either be to slow or way too fast. I checked my sensitivity and its what i always use. Please help

Link to comment
Share on other sites

  • Netduma Staff

I did everything you guys said but still lagging ugh. My average ping is between 32 to 40. And my diagnostic test results are ping good, jitter- exceptional, spikes- exceptional, packet loss- no loss. I also added the pa3 in host filtering loaded profile as ultimate cod. In my geo filter i have distance set as 2805km and ping assists at 50ms...not sure if its right. What else can i do? When im playing the game running feels smooth but gun fight is so hard going left to right or up and down it would either be to slow or way too fast. I checked my sensitivity and its what i always use. Please help

 

Your ping and settings seem pretty good - we usually recommend below 50ms ping for a decent gameplay experience. If the game feels relatively smooth until you get into a gunfight it usually indicates the other player involved in the gunfight has a bad connection. You would notice lag on your end even when not interacting with other players. Unfortunately we can't fix lag caused by other players - that's down to their connection and how the game lag compensation deals with it.

 

I'd recommend denying any hosts that give you really bad gameplay and looking for closer or better performing servers you could force. Also make sure you've got Anti-Flood set to 70/70, reset Device Prioritisation and apply, and put your console in Hyper Traffic :)

Link to comment
Share on other sites

Im trying to edit the nameless device to ps3 because i have about 4 nameless devices and i dont know which one is. However i cant add it because on left of the general purpose tab i have no other tab i can click to edit it. Thank you for all the help in advance

I think you might be in the wrong place to edit the name?

 

Device Manager (on the left)

-Click 'Edit' (on the top middle)

 

It should show something like this

 

 

 

 

6orNVurzSUy54FfDLnX3Ng.png

 

 

 

Where it shows PS Tai, that is my console and where I switched the 'general purpose' to 'game console' and the device name from 'nameless' to PS TAI for my ps3 console

 

 

Now, to figure out which device is which (since you said you couldn't figure out which device is which) you just look at where it says 'active'. Mine ps3 console shows the 192.168.88.220, but for you, it could be different? Go on your PS3>Settings Column>Network Settings>Settings and Connection Status List> Now, from here check to see what is the IP Address. For me, it shows the 192.168.88.220 That's how I know I used the assigned correct device.

 

I did everything you guys said but still lagging ugh. My average ping is between 32 to 40. And my diagnostic test results are ping good, jitter- exceptional, spikes- exceptional, packet loss- no loss. I also added the pa3 in host filtering loaded profile as ultimate cod. In my geo filter i have distance set as 2805km and ping assists at 50ms...not sure if its right. What else can i do? When im playing the game running feels smooth but gun fight is so hard going left to right or up and down it would either be to slow or way too fast. I checked my sensitivity and its what i always use. Please help

I see you did everything correctly here from what I see, but I do not recommend changing anything after you went from Profile tab (on the left) to CoD Ultimate, especially the distance since it makes me terribly laggy when finding hosts. So, after you select CoD Ultimate from the Profile tab on the left, do not change anything. Make sure the CoD Ultimate automatically sets up everything and your distance should be set to something like 111 I think is the maximum lowest? Also, your home location should now be changed into the middle of the ocean if you did this correctly and ping assist should now be set to 50.

 

Here's how mine looks

 

 

 

 

M7MBiIyUTwq9ARTmyQKgIA.png

 

 

 

After you have done this, make sure to press the 'Load profile' under where it says personal settings after you scroll all the way down and wait a few minutes or seconds until it automatically changes everything, and don't change anything after that.

 

 

 

iPgoolNSRSaM7wSBUBaPgQ.png

 

 

 

Now, check to see if your settings look something like this (Ignore the LT device, that is actually my laptop haha but I wanted to un-add that, but instead I disabled it)

 

 

 

H9FgkEAxSt6LWb8_U4cZeA.png

 

 

 

 

 

CoHS2fA0SbC7rELirGOl8A.png

 

 

 

 

 

afCwer_tSRiNXL03SvOz6w.png

 

 

 

Remember to not change anything, especially distance since it might make you lag. Although, sometimes it can be great to find a near host or dedicated server, I don't recommend it for now.

 

Try searching for a game now and remember it might take 30 seconds to maybe 1-2 minutes to find a perfect game.

 

Also my nat is type 2

 

Not sure if Nat type matters a whole lot, mine shows that it is 'open' instead of 'moderate'. I'm using a wired ethernet connection to my netduma router to my ps3 console and enabled dmz through my router modem combo from my isp.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...