KzarofBacon Posted December 15, 2017 Share Posted December 15, 2017 I had two different issues the last two nights that I may need help with. 1st - I was on BO3 last night and after 45 minutes or so, I was constantly being kicked out of the game. I'm on XB1 on a wired connection to my R1. My R1 is on 1.03.06(i) and my provider is Comcast. My speeds are average for the US but are almost always consistently 22 ping, 30 down and six up. For all of Comcast's faults, my speeds are almost always consistent. I did notice that my phone was dropping connection to the Wifi during that time too. I had previously unplugged both my modem and router, let them sit for a minute, and then plugged in the router first. Once it was fully functioning, I powered on the R1. This was before my gaming issues and I didn't do it after I had problems because it was late and I was irritated. My speeds this morning were below average ranging from 12-18 down, ping was all over the place and up was 4 or so. This was on Wifi and I didn't get time to test a wired connection. My plan after work is to get home and test it both on wired and wifi over a period of time to see what speeds I'm getting. I do know that my speeds are NOT capped at the router as both sliders are at 100% and it's setup properly. The other issue that I'm having and what prompted me to reset the router and modem before gaming last night is that my XB1 is telling me that it can't get a Teredo IP address. I tried playing Pubg on the Xbox the other night and played one game before the game would not let me join a match. I found a post on Reddit with the error code and tested my multiplayer connection in the XB1 settings. The XB1 is telling me that it can't get the Teredo IP and to make sure that UDP port 3544 is not blocked. My first thought is that these two items are unrelated and that I need to get my connection issue resolved first. But before I do anything besides power cycling the modem and R1, I wanted to see what the R1 folks thought so that I don't screw up my R1 or how to resolve the Teredo issue. FYI that the XB1 networking section shows my NAT as unknown but BO3 shows it as open. TIA for any assistance. Link to comment Share on other sites More sharing options...
Netduma Staff Netduma Jack Posted December 15, 2017 Netduma Staff Share Posted December 15, 2017 Do you see any blocked servers pop up when you're booted from the game? If you do, try increasing your Geo-Filter radius and perhaps disable strict mode. Also provide us with the ID of those blocked servers as we may need to add them to our cloud database. As for the Teredo issue, try disabling UPnP and port forwarding on your ISP hub, then enable UPnP only on the Netduma. Link to comment Share on other sites More sharing options...
KzarofBacon Posted December 15, 2017 Author Share Posted December 15, 2017 I didn't have the router's page open while playing but I can look later. Would it boot me mid-game if that was the case? I'm less inclined to think that's a R1 issue and more of a Comcast issue. I'll double check though. Re: Teredo, I don't have anything setup on the router. I do have one Port Forwarded on the R1 for BO3. Microsoft's search function returned a page that suggested I disable UPnP, reboot the router, then re-enable it. I'm more comfortable following your advice than their's. Is that something you suggest? Thanks. Link to comment Share on other sites More sharing options...
Netduma Staff Netduma Jack Posted December 16, 2017 Netduma Staff Share Posted December 16, 2017 I didn't have the router's page open while playing but I can look later. Would it boot me mid-game if that was the case? I'm less inclined to think that's a R1 issue and more of a Comcast issue. I'll double check though. Re: Teredo, I don't have anything setup on the router. I do have one Port Forwarded on the R1 for BO3. Microsoft's search function returned a page that suggested I disable UPnP, reboot the router, then re-enable it. I'm more comfortable following your advice than their's. Is that something you suggest? Thanks. You should only have UPnP or Port Forwarding enabled, not both. UPnP will automatically open the ports needed for the game - but can cause conflicts when you've already manually opened the port. (It's not a massive deal, but it can slow down the Netduma interface). I'd suggest removing the Port Forwarding rule you have set, then disable UPnP, reboot from Settings > Miscellaneous and enable it Link to comment Share on other sites More sharing options...
KzarofBacon Posted December 16, 2017 Author Share Posted December 16, 2017 You should only have UPnP or Port Forwarding enabled, not both. UPnP will automatically open the ports needed for the game - but can cause conflicts when you've already manually opened the port. (It's not a massive deal, but it can slow down the Netduma interface). I'd suggest removing the Port Forwarding rule you have set, then disable UPnP, reboot from Settings > Miscellaneous and enable it That explains it. I had numerous issues last night including the interface being quite slow. I'll fix it ASAP. Greatly appreciate the assistance! You peeps are the best. PharmDawgg, Netduma Jack and Netduma Fraser 3 Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted December 17, 2017 Administrators Share Posted December 17, 2017 All good now? Link to comment Share on other sites More sharing options...
KzarofBacon Posted December 19, 2017 Author Share Posted December 19, 2017 Everything seems good to go now. Thanks for the help. If anything pops up again, I'll ask for more assistance. Greatly appreciate your product and support. Netduma Jack 1 Link to comment Share on other sites More sharing options...
PharmDawgg Posted December 19, 2017 Share Posted December 19, 2017 Glad everything is going well. Link to comment Share on other sites More sharing options...
Recommended Posts