Ruthless24 Posted September 29, 2016 Share Posted September 29, 2016 I started to notice very slow downloads speeds and constant buffering when streaming Netflix and Hulu throughout my day and I'm having to reboot my modem just to get my connection back. I called the cable company a I was only able to achieve 4mbps...when we took the netduma out of the equation my speeds went back to normal which is 50/5. I just recently bought a new Xbox One S and so far it's taken me about 2days just to re-download BO3...why is this happing. Just did a speed test and literally got 50ping 1.12Down and 5.55Up. I did some reasearch and noticed others are having the same problem. So far this is what I have tried: Enter your speeds into bandwidth settings Preemtive Algorithm since I only have 50/5 100% anti-flood Share excess enabled Reset device prioritisation & apply Disable IPv6 in WAN, LAN & misc Disable deep packet in misc Do a wired speed test from a PC I have turbo mode disabled since I'm not at 100mbps Does anyone have a solution or suggestions? Link to comment Share on other sites More sharing options...
Slipknot31286sic6 Posted September 29, 2016 Share Posted September 29, 2016 Turn on turbo mode and reactive.. Boom fixed Link to comment Share on other sites More sharing options...
abc123 Posted September 29, 2016 Share Posted September 29, 2016 and disable deep packet inspection Link to comment Share on other sites More sharing options...
ColonicBoom Posted September 29, 2016 Share Posted September 29, 2016 Make sure you remove the Xbox from Hyperlane when downloading games/updates to your Xbox. Hyperlane is only for small gaming packets, it will slow you right down if a large transfer hits it. Link to comment Share on other sites More sharing options...
abc123 Posted September 30, 2016 Share Posted September 30, 2016 if you are talking about internet speed do the following: Congestion Control: -Change the radio button to reactive -Make sure the sliders are 100% each -Click Bandwidth and set it to appropriate values Settings -> Misc -UNCHECK Enable deep packet processing. -CHECK turbo mode report back Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted September 30, 2016 Administrators Share Posted September 30, 2016 Do what has been said above and also make sure ethernet cables are in correctly. Have you got your PC in hyper traffic? If so take it out, only meant for low latency traffic. Link to comment Share on other sites More sharing options...
Ruthless24 Posted September 30, 2016 Author Share Posted September 30, 2016 Changing the algorithm to reactive and having turbo mode ticked worked! I only have my Xbox under hyperlane. When doing the DSLreports test does it make a difference if the geofilter is on? I mean is there specific settings that should be on or off when doing the DSL test? Trying to get +A across the board Link to comment Share on other sites More sharing options...
Slipknot31286sic6 Posted September 30, 2016 Share Posted September 30, 2016 Nah geo filter only works for gaming not testing. You start at 100 cc, go backwards 5% at a time till u get 10 ms or below jitter, A+ is 5ms or below Link to comment Share on other sites More sharing options...
Ruthless24 Posted October 8, 2016 Author Share Posted October 8, 2016 Getting +A is almost impossible! Started at 100% dropping 5% each time both download and upload I was able to get +A once I believe at 70%, I re-test and I lost the +A...correct me if I'm wrong here but the goal is to have the sliders set to consistanly give me +A Link to comment Share on other sites More sharing options...
Slipknot31286sic6 Posted October 8, 2016 Share Posted October 8, 2016 Make sure you are moving both sliders. Yes 70/70 gives auto A+ since netduma staff says buffer bloat happens when more than 70% of your connection is being used. My sweet spot is 98/98 for A+. Tho I changed my modem from Motorola sb6121 to tp link tc-7620. Cured a lot of jitter Link to comment Share on other sites More sharing options...
Ruthless24 Posted October 8, 2016 Author Share Posted October 8, 2016 Would you recommend TP-Link? Currently I have a Netgear CM600...I used to have a Motolora SBG6500 Link to comment Share on other sites More sharing options...
spenn Posted October 8, 2016 Share Posted October 8, 2016 I purchased the NetdumaR1 about 2 months ago. I'm on the 6h version. I'm running it as the only router. The Xb1 and the PS4 are both wired to Netduma. However, my speeds are awful. I have TWC ultimate at 300dl 20up. When running speedtest through modem the speed is there. When wired via Netduma the latency goes crazy and the download speeds drop to around 1mbps. I've tried every change with Netduma and ran speeds via ethernet (on pc and both consoles). I've set the bandwith in Netduma done all the normal 'optimize settings'. Turned off deep packet processing, ip6v. I've tried turbo, super turbo. I've set congestion controls (when super wasn't on). I'm at a loss. I've purchased 3 separate modems. The latest modem is the TPLINK TC7620. No matter what I do I can't get this to work. Please let me know what information I can provide. I want to use this router but my frustration has grown tremendously. Any ideas? Link to comment Share on other sites More sharing options...
Administrators Netduma Fraser Posted October 10, 2016 Administrators Share Posted October 10, 2016 Bufferbloat only happens around the point of saturation and at 70% anti-flood it does not saturate so I wouldn't fret over trying to get A+. I purchased the NetdumaR1 about 2 months ago. I'm on the 6h version. I'm running it as the only router. The Xb1 and the PS4 are both wired to Netduma. However, my speeds are awful. I have TWC ultimate at 300dl 20up. When running speedtest through modem the speed is there. When wired via Netduma the latency goes crazy and the download speeds drop to around 1mbps. I've tried every change with Netduma and ran speeds via ethernet (on pc and both consoles). I've set the bandwith in Netduma done all the normal 'optimize settings'. Turned off deep packet processing, ip6v. I've tried turbo, super turbo. I've set congestion controls (when super wasn't on). I'm at a loss. I've purchased 3 separate modems. The latest modem is the TPLINK TC7620. No matter what I do I can't get this to work. Please let me know what information I can provide. I want to use this router but my frustration has grown tremendously. Any ideas? Reactive Algorithm 100% anti-flood Share excess enabled Reset device prioritisation & apply Disable IPv6 in WAN, LAN & misc Disable deep packet in misc Enable turbo mode Enable super turbo mode Ensure the ethernet cables you're using connecting the R1 to hub & R1 to PC are Cat5e+/can handle your speeds. Do a wired speed test from a PC Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.